Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   Who's ready for a dumb question? (http://www.wranglerforum.com/f218/whos-ready-for-a-dumb-question-123655.html)

Darkside 11-20-2011 06:37 PM

Who's ready for a dumb question?
 
So for the last few weeks I have been chasing problems around on my YJ. So all other issues resolved I have one that has been plaguing me. I replaced the slave cylinder and bench it (twice) most if not all the air should be out of it. When I press the clutch in and it is in first gear it will grind and grab. I pulled the engine and checked the clutch ( also make sure I didn't put in backwards). I reset the pilot bearing after I found it out of the fly wheel. Would not having the pilot bearing set right one the flywheel cause it to grab and grind or am I looking for a new clutch.

frghtlnr2005 11-20-2011 07:59 PM

You've still got air in the master, Needs to be bled just like bleeding breaks, need to have 2 people and make sure you keep your resevoir full.

Pedal down open bleeder, close bleeder, release pedal and repeat should have it after about 3 times

banks316 11-20-2011 09:32 PM

Vacc pump works great for bleeding brakes and clutches by yourself

acastiaux2 11-21-2011 09:54 AM

When i replaced my clutch i didnt need to bleed it at all


All times are GMT -5. The time now is 02:09 PM.