Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   need help (http://www.wranglerforum.com/f218/need-help-134443.html)

peterbiltjunkie 01-20-2012 10:11 PM

need help
 
engine would idle smooth before nutter but would fall on its face at nything beyond 2000 rpms. i nuttered it and now i cant even get it to idle smoothly. starts hard and runs like sh#?! any ideas where i went wrong? thanks in advance

RednekYJ 01-20-2012 10:17 PM

Whats your timing at? I think stock it's 8degrees and when you nutter it you need to be at 11-12

peterbiltjunkie 01-21-2012 02:10 PM

set timing at 12 degrees but just cant get i to even out I dont know if maybe fuel mix is off or what. What is good position for needles

Nubby55 01-21-2012 10:24 PM

I put mine at about 3/16" set timing with vac. disconnected @ 10* BTDC then adjust the carb.

peterbiltjunkie 01-22-2012 11:24 AM

did you seat them and then adjust them out 3/16'' ?


All times are GMT -5. The time now is 01:37 PM.