Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   Yj Hard Door Problem HELP PLEASE ! (http://www.wranglerforum.com/f218/yj-hard-door-problem-help-please-137329.html)

Bluegrass 02-03-2012 04:44 PM

Yj Hard Door Problem HELP PLEASE !
 
I took the hard doors of a 89 to put onto a 87 buy they do not line up with the latches ! Anyone know why or how i can go about fixing ??

Ibuildembig 02-03-2012 04:45 PM

None of them fit exact, you can adjust the hinges on the front of the tub and the striker on the back.

Bluegrass 02-03-2012 05:33 PM

Can you explain a bit on that? I don't understand how to adjust them. I can't go without doors right now it's still pretty cold at night and to cold to take off the hard top and go with the low doors.

Ibuildembig 02-03-2012 05:38 PM

The bottom hinge that bolts to the tub right above where it says JEEP. Loosen those torx and you can move the hinge around.

Bluegrass 02-03-2012 05:46 PM

it is sitting about a half inch to high for the door to line up. I tried to move the door strike but i don't see a place for it to re drill it.

Bluegrass 02-03-2012 05:53 PM

ok.. i think i got it.. I need to loosen the plates on the door it self then put it on. Line it up .. Then tighten to fit.

Thanks for the help...

Ibuildembig 02-03-2012 05:54 PM

you can, but most of the time the one on the tub needs adjusting

Bluegrass 02-04-2012 04:27 AM

thanks Fruitland.. that will save me a good bit of time and pain i'm sure..

Bluegrass 02-04-2012 05:26 PM

HELL YEAH.. just got it 14 hours ahead of time before i lost the time frame. Thanks for all the help.. Only stripped three bolts along the way.

JEEPASAURUSREX 02-04-2012 05:47 PM

redrill the striker ? if you loosen the torx on the end , the striker itself they are usually in a bigger hole and you can move the pin around once loose.

Bluegrass 02-05-2012 11:20 PM

thanks Rex but got it worked out with moving the door hitches around.


All times are GMT -5. The time now is 10:33 PM.