Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   water in my oil (http://www.wranglerforum.com/f218/water-in-my-oil-141519.html)

harleyman33 02-22-2012 04:16 PM

water in my oil
 
ok...I got a 91 2.5L...I started gettin a little lifter tap noise...so i checked the oil and had alot of rust on the dipstick...oil was fine..also around pcv valve was watery oil..had that oily water look...then today i checked the oil again and now the oil in the pan is startin to get that creamy look to it....it doesnt tick when i first start it...but when it reaches norma temps it starts...and its not consistant...its quiet then loud then quiet then real loud then stops for a bit..then starts again...what the hell is the prob...i cant stand noisy engines...almost wanna blow it up so i have excuse to rebuild it...any help would be nice and appreciated....and also air filter looks like engine puked oil ad little water into it....all over the top of the filter

Mr Mac 02-22-2012 04:17 PM

Usually water in the oil is indicative of a head gasket gone bad. Does it overheat at all?

kmanator 02-22-2012 04:20 PM

And anti=freeze eats the babbet material off the main/rod/cam bearings...so...you might get your wish soon :whistling:

harleyman33 02-24-2012 06:48 PM

no it doesnt overheat...it doesnt smoke like alot is in the cylinders or anything...there is just enough in the pan that it shows a little on the dipstick...when i pull dipstick it is the brown milky look along the edge of the stick.

ItsSabby 02-25-2012 08:35 AM

Have you changed your PCV valve? It could be clogged and allowing moisture to build up in the crankcase.

Kahuner 02-25-2012 10:54 AM

X2 what ItsSabby said!! Great idea!!

Take it one step further and pressure test the cooling system. If it holds without the needle moving at all, it eliminates a bad head gasket, cracked block etc.

Good luck;
Kahuner

Jon70 02-25-2012 06:41 PM

When you change the PCV valve you may want to check the crankcase vent to the rear of the PCV.


All times are GMT -5. The time now is 03:04 AM.