FS: Pair of .500 DOM lower control arms + pair .375 DOM controls (KS)
I have a set of lower control arms that are 2" .500(1/2") DOM drilled and tapped for 1.25" Johnny Joints. These are completely beefy, they have wrench flats, and the ends are chamfered. I had them built to match my front control arms. They are 33" long. Each have a left hand and right hand end so adjusting length can be done on the vehicle without dropping a bolt.
The uppers are 1.75" .375(3/8") walled DOM drilled and tapped for 1.25" Johnny Joints. They are all complete overkill with the same treatment as the lowers. They are 34" long.
I'm selling all 4 control arms for $500 plus shipping to your door.
I think I'm going to pick up another one tonight. :eek:
12-28-2007 08:11 AM
I've had quite a bit of questions about the length of these arms so I thought I would give an update to correct the confusion.
The length listed is the body length of each control arm. With the jamb nuts installed on each end and the length to the bolt hole you add ~5" of length to each body measurement. So the lower control arms shortest possible length is 38" bolt hole to bolt hole. That still leaves 2.5" worth of JJ stuffed inside the control arm so there is plenty of adjustability.