Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   Noise while clutch is out (http://www.wranglerforum.com/f218/noise-while-clutch-is-out-144973.html)

raycer 03-08-2012 07:45 AM

Noise while clutch is out
 
My yj started making a loud squeally, rattling sound that goes away when I push the clutch pedal in. Is that the throw out bearing?

crafty 03-08-2012 08:12 AM

Don't think so, usually that makes noise when you push the clutch in. Just replaced mine this wknd.

raycer 03-08-2012 08:14 AM

Really?

The Jeep drives and shifts fine though, just noisy

crafty 03-08-2012 08:21 AM

Pull your front driveshaft and see if the noise stops. Sounds strange but try it.

raycer 03-08-2012 08:47 AM

Come to think of it, my front shaft universals are going...

crafty 03-08-2012 09:24 AM

That could be it. I had my actual clutch completely fall apart once in my first rig but that is rare. Pulling the driveshaft and noise goes away then it is probably something with the driveshaft or universals.

raycer 03-09-2012 04:46 PM

Something to add. I also notice a whine that is present and responds to the RPM range, and it goes away if I remove the tranny out of gear; clutch inor out, it maks the whine

raycer 03-10-2012 09:31 AM

Anymore ideas? I'm going to pull the plug on the tabby and check the fluid tomorrow and probably the t case too

darkproximity 03-10-2012 09:39 AM

Sounds like its your input shaft bearing on the transmission itself

raycer 03-10-2012 10:33 AM

Would that entail a rebuild or is it something that can be done with rebuilding? The teanny itself was rebuilt not very long ago by previous owner.

Garyk 03-10-2012 01:56 PM

Does this noise happen when moving or stopped????If it makes it while stopped it could be your pilot bearing or as darkproximity says, the input shaft...
Still would not rule out the throwout bearing either

raycer 03-11-2012 02:52 PM

It does it stopped or rolling


All times are GMT -5. The time now is 03:08 PM.