Jeep Wrangler Forum

Jeep Wrangler Forum (
-   TJ General Discussion Forum (
-   -   Soft top installation help! (

CrusherCurtis 03-17-2012 09:46 AM

Soft top installation help!
This is my first time dealing with a soft top. For a TJ

So I bought a top off craigslist that was "new". This was my first mistake. The guy I got it from claimed he installed it once and took it off right away. I though this was weird but whatever I bought it. He said is was a bestop. I got it home and noticed a few problems.

First off where the top mounts to the front with the 16 screws, there are no "pockets" for the corners. There's only a plastic strip that goes straight across left to right. I'm considering cutting the plastic strip where you see the red line to make it fit. What do you think:

In the back where it buttons up to the 6 snap buttons, it doesn't line up at all. There are 3 buttons on both sides. On either side when I attach the center button the 2 outer buttons won't reach there respective buttons. In the photos I have the center button attached and as you see the outer buttons won't reach. I"m considering cutting the fabric up until the top to make the reach.

The top is also doesn't have a center pocket for thank bar in the center. The old top has it:

The original soft door upper frame is sewn in and the replacement fabric is all velcro. Is this the norm? Does everyone hack up there original upper doors to use these replacements:

Redsand 03-17-2012 09:57 AM

Is this for a yj?

CrusherCurtis 03-17-2012 10:02 AM


CrusherCurtis 03-17-2012 11:49 AM

Anybody before I hack?

Jerry Bransford 03-17-2012 11:54 AM

Don't hack it up, nothing should get cut or trimmed for installation!

That strip across the front edge is screwed to the header and it should not be modified. It's a bit tricky to get the top wrapped around the header (you do have the header with the clamps I hope!) properly so the top is properly positioned to be used. The top is screwed to the header and the header secures the front edge of the top to the windshield frame.

Only the factory sews the upper windows in place around the upper door frames. Replacement windows are held in place by velcro since aftermarket buyers don't have industrial sewing machines.

All times are GMT -5. The time now is 06:07 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.