Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   JK General Discussion Forum (http://www.wranglerforum.com/f274/)
-   -   OBA tank hook up and all fittings (http://www.wranglerforum.com/f274/oba-tank-hook-up-and-all-fittings-148752.html)

catalinafairview 03-24-2012 11:57 PM

OBA tank hook up and all fittings
 
Hello all,
I recently hooked my ARB compressor in my 2012. I purchased a 1 gal viar tank and I want to know what the best have done to hook up tanks. The tank has 4 npt input/outputs. One is on the top, one on bottom, and one on each side of the tank. What goes where. I believe there needs to be a condensation valve on the bottom one, correct? Does the air input from the compressor go to the top?What do I need to hook it up? Are you running hoses? I plan on placing the tank near the e-brake bracket that was removed for my lift (above and in front of the rear axle) I know I need to make sure there is clearance. I would like to place a quick disconnect in the front and the rear.
Sorry so many questions and plan on more:)
Thank you

Vin 03-25-2012 01:46 AM

The drip valve for condensation goes on the bottom. the other fitting go where they fit best. I put the intake hose on top because it is closest to the compressor. If it were closer to the side, I would have put it on the side.


All times are GMT -5. The time now is 08:55 AM.