Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   General Jeep Discussion (http://www.wranglerforum.com/f19/)
-   -   what else do I need to make this work? (http://www.wranglerforum.com/f19/what-else-do-i-need-to-make-this-work-15407.html)

dbwvu 02-04-2008 11:15 PM

what else do I need to make this work?
 
What parts would one need to make this a somewhat bolt-on application to replace my d35

gears, shafts, brakes, bearings? thanks, db

http://www.jeepsareus.com/Merchant2/...Code=Wrangler1

foxinthemudd 02-05-2008 03:36 AM

try posting in the general disscussion thread you will probably get more hits on it.

1BLKJP 02-05-2008 03:55 PM

You'd also need a yoke, and a carrier/spider gears or some sort of a full case locker. Otherwise your master install kit for your gears will have all of the new seals and bearings you need for the gear setup. You'll need to buy new bearings for the shafts as most don't send them with bearings or retainer rings. And depending on if you just went with your drums from the 35 or new disks then there are different retaining rings.

George T. 02-05-2008 06:19 PM

isnt 600 bucks a little expensive for just the housing?

dwdrums801 02-05-2008 10:58 PM

not really


All times are GMT -5. The time now is 10:50 PM.