Few months back I put the seal on the pass side what a pain! Today I noticed Gear oil on the driver side. The question I have is does that side have a c clip as well I'm sure it does but figured I would ask. Also any tips to get the job done a little faster? Thank all!
05-18-2012 02:51 PM
Im curious myself... my passenger side started to leak after we swapped the U-joints in the front shafts.
05-18-2012 03:02 PM
The pass side is a pain I have done that side getting the new seal in is a process lol
05-18-2012 07:19 PM
Ok got the seal out but I took the ring gear and carrier out to remove it. Any advice on getting the gear back in?
05-18-2012 07:22 PM
Just make sure you put back like you took it apart. Did you have any shims?
05-18-2012 08:11 PM
I did not see any. Will I need to reset the preload?
05-18-2012 09:32 PM
As long as you didnt mess with the pinion, you wont need to do anything but put the carrier back in and tighten it down. The pinion is where the preload is set. And where the spacing shims are put.