Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ General Discussion Forum (http://www.wranglerforum.com/f282/)
-   -   Help with Track Bar (http://www.wranglerforum.com/f282/help-with-track-bar-16254.html)

BPD119 03-04-2008 07:24 PM

Help with Track Bar
 
I have the Full traction track bar. it has a screw in tie rod end with the nut and cotter pin. recently i noticed the nut was loose and it has been making a clunk noise when i turn, and hit bumps.

i took out the cotter pin and attempted to tighten the nut down, but the whole stud and nut turn, after a while i was able to finally get it somewhat tight, but this doesnt seem normal, i am not impressed with this track bar, is there an alternative one to use or is just a bad tie rod end? Also if i do get a different bar is it going to make a difference that i had to drill out the hole on the axle end for the bolt to fit with the new full traction one?

any help would be great

MR.CLIFFORD 03-04-2008 08:29 PM

I usually put a jack under rod ends if they like to move inside the taper. Just put a little pressure on the rod end to keep it from spinning the tighten it again.

If that doesn't work out well ditch it and buy a JKS. :D

Joe Dirt 03-05-2008 02:52 AM

I got so sick of mine that I replaced it with a better one.

BPD119 03-05-2008 01:08 PM

Joe ehat one did you go with?

Triple88a 03-05-2008 06:52 PM

Quote:

Originally Posted by MR.CLIFFORD (Post 201864)
and buy a JKS. :D

what he said ^ :wavey:

rando 05-04-2012 05:01 PM

i have the same trac bar on my jeep. i am wanting a replacement tie rod for it does any body have a part number or description to get one at a parts store.

UnlimitedLJ04 05-04-2012 05:22 PM

Quote:

Originally Posted by MR.CLIFFORD (Post 201864)
If that doesn't work out well ditch it and buy a Currie TJS or TJJ model. :D

fixed it for you.:popcorn:


All times are GMT -5. The time now is 12:15 AM.