Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   Communications and Electronics (http://www.wranglerforum.com/f40/)
-   -   Head unit and sub are working, speakers all around are not... (http://www.wranglerforum.com/f40/head-unit-and-sub-are-working-speakers-all-around-are-not-163888.html)

camtron3712 06-01-2012 11:24 AM

Head unit and sub are working, speakers all around are not...
 
Yesterday i hit a bug bump in the road. all my speakers went out except for the sub. I took the head unit out, checked all the connections and the remote turn on was hanging loose. hooked it back and still not working... hmmm. as far as the remote turn on, there was not one wire disconnected.. PLEASE HELP, i dont know what the problem could be.. In a few minutes im going to go take all the speakers out and check the connections to them. Is it possible it could be from a short?

Ibuildembig 06-01-2012 11:31 AM

Are you amping the other speakers or just using head unit power?

camtron3712 06-01-2012 11:33 AM

All the other speakers are from the head unit, the only thing powered from the amp are the two subs i have

Ibuildembig 06-01-2012 11:34 AM

Check the power and ground on your head unit, if they are all good...your head units amp is fried.

camtron3712 06-01-2012 11:53 AM

The other day it happened, the remote turn on wire was disconnected, i hooked it up and they all started working again.. Yup just disconnected and reconnected the ground, battery(red), and constant(yellow)

Ibuildembig 06-01-2012 01:11 PM

The remote wire has nothing to do with the amp that's built in the head unit. If it came loose and shorted to ground, it could have blown up some components in your radio.

Jma20a 06-01-2012 09:57 PM

I would say bad connection vs. fried headunit. Fried headunit would have more problems than he is having unless its a sony :)

camtron3712 06-01-2012 10:05 PM

Quote:

Originally Posted by Jma20a
I would say bad connection vs. fried headunit. Fried headunit would have more problems than he is having unless its a sony :)

Took the wiring harness out.. disconected and reconnected and still not working.. so must be fried

Jma20a 06-01-2012 10:40 PM

If u have a digital multi meter you can check the connections with the unit running

americonium 06-02-2012 05:41 AM

Try disconnecting each set of speaker leads, one at a time from the radio harness while the radio is on. It might just be a sorted speaker wire, and that will cause the headunit to go into protection.


All times are GMT -5. The time now is 11:03 PM.