Hi all, just installed some Lightforce lights with the Lightforce loom on a 2012 JK. All seems to be working fine except the high beam from where I joined the feed isn't working. When I disconnect the feed it works fine again?? Anybody else had same problem?
06-17-2012 04:33 AM
Is the harness relayed?
Does it have a cap and resistor wired in?
06-17-2012 09:54 AM
What is the wattage on the auxiliary lights and did you use a relay?
06-18-2012 12:44 AM
Thanks guys, yes its run through a relay, just been reading about capacitors & diodes, think I might have to give it a try.