Jeep Wrangler Forum

Jeep Wrangler Forum (
-   TJ Tech Forum (
-   -   Installed new mulitfunction switch and now my blinkers and hazard light dont work. (

tkoTJ 04-04-2008 03:40 PM

Installed new mulitfunction switch and now my blinkers and hazard light dont work.
hi Jeepers,

i was hoping someone ran into this issue. i just replaced the mulitfunction switch on my 01 Wrangler TJ and fog and headlights work fine...however now my blinkers and hazard light do not i need another relay switch separate from the multifunction switch?

when i swapped it out it was a 1:1 plug, unless i'm missing something here.

any help is appreciated. thanks in advance!

jpdocdave 04-04-2008 05:14 PM

i just read your other thread about your battery probs, and not getting jeep to start even with a jump, w/ that in mind check fuses, flashers, and relays before you dig any further. sometimes trying to jump battery, that weak can blow fuses and so on.

tkoTJ 04-04-2008 05:33 PM

Hi jp

i've checked the fuses in the glovebox for the blinkers and they look fine. By relays you are referring to the set next to the battery'?

jpdocdave 04-04-2008 06:19 PM

ya, just look in owners manual for fuses, relays, and flasher related to the turn signal system. start w/ the basics is my first step.

Triple88a 04-04-2008 06:34 PM

maybe u puled the blinkers switch wires off or soemthing?

sorry cant be much help on that as my light switch is not on the steering column.

jeeperman 04-04-2008 06:48 PM

If the blinkers and flashers don't work, it sounds like something is grounded that shouldn't be. (At least that was the case when I did my LED lighting all around). Check all of your wiring to make sure nothing is shorting out. This could go along with your battery issues. Good luck.

All times are GMT -5. The time now is 06:51 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.