Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   Oregon Jeep Forum (http://www.wranglerforum.com/f62/)
-   -   New Project - Rear Bumper replacement (http://www.wranglerforum.com/f62/new-project-rear-bumper-replacement-177099.html)

oregonmp03 07-30-2012 01:02 AM

New Project - Rear Bumper replacement
 
Built this on Saturday using 3 x 4 " steel and a piece of 4" flat iron for the top to clean it up. I'll be adding the oversized tire carrier once the cylinder for the swing arm shows up in the mail. Also got the CB antenna bracket up and mounted (temporarily until the carriers finished). Everything will be powder coated after it's done.

And yes I think the passenger side is a bit low, need to fix my bolt holes before it's finished. Had to eye ball it the first time.

http://i48.tinypic.com/2przifo.jpg

http://i49.tinypic.com/rw1lvo.jpg

Cold 07-30-2012 08:34 AM

Nicely done!

oregonmp03 08-16-2012 02:44 AM

http://www.wranglerforum.com/f33/new...er-180779.html reposted here with the new updates

scottmphoto 08-16-2012 11:30 AM

Did you cut your body on both rear corners?

oregonmp03 08-16-2012 02:46 PM

nope, didn't do any altering of the jeep body at all, the only actual alteration to the jeep itself was two bolt holes in the frame

Baby Huey 08-16-2012 08:25 PM

Good Job !:thumb:

Hopefully I can get started on mine this winter, I want to build a set of sliders too to cover up the naked hole in the side of the body...

Good goin ! :thumb: "BH":popcorn:

oregonmp03 08-17-2012 02:21 AM

got it all welded together and mounted up along with the jerry can quick disconnects. Just need to finish all the endcaps, latch, and the actual jerry can holders, then off to powder coat

oregonmp03 08-25-2012 02:07 PM

http://www.wranglerforum.com/f33/new...er-180779.html

finally ready for powdercoat, check out the new pictures


All times are GMT -5. The time now is 07:38 AM.