I just spent a fortune on getting a new clutch and new input shaft installed... And after a week of driving the new clutch/input shaft, i started my jeep up one morning and there is a slight squealing noise. The squealing noise will go away once I put a little bit of pressure on the clutch pedal. I talked to the mechanic who did the work and he doesnt have any idea. I REALLY want to avoid taking it back. Any ideas what it could be? did they mess up? can it be fixed easily? Any input would be greatly appreciated.
09-17-2012 06:12 PM
Pilot bearing possibly.
09-18-2012 12:31 PM
Pilot bearing or release bearing. Either can make a noise that will go away/change when the pedal is depressed/released. Were these replaced when the clutch was installed?
09-20-2012 08:24 PM
I don't think they did, I requested a new clutch kit. Should they have changed out those parts?
09-20-2012 11:40 PM
Should have but the probably didn't from what you are describing.
09-21-2012 07:53 PM
That's a bummer. Is there any possible damage that can come from it being bad?
09-21-2012 08:25 PM
A lot of kits come with the pilot & throwout bearing so there's a chance they were replaced.