Jeep Wrangler Forum

Jeep Wrangler Forum (
-   TJ General Discussion Forum (
-   -   I am baffled and would like some opinions PLEASE lol (

Achilles515 10-10-2012 07:12 PM

I am baffled and would like some opinions PLEASE lol
I've got a '99 Wrangler, 4WD Automatic. No mods or anything like that, completely stock. Drove it to the store today, was't in the store 5 minutes, came out and she wouldn't start. Acted like the battery was dead. No click or anything. Dash lights work, headlights work, none of it is dimmed either. Luckily, I was right next to an auto shop. Brought a battery tester over, teste out fine. The fuse still clicks, tried hitting the starter, tried crossing the solenoid, nothing. Took the positive cable and touch the solenod and nothing, tried putting it in every gear to start and nothing lol. I am baffled. Anybody have any ideas?? I thought about the battery terminals but they're clean and everything is powered up anyway.


tallzdatank 10-10-2012 07:18 PM

neutral safety switch, or starter. more likely neutral safety switch.

90mph 10-11-2012 12:22 AM

I assume you mean the solenoid clicks, not the fuse. If so, that rules out the solenoid...usually. so the next most likely culprit is the starter. I'd replace both as an assembly. Good luck.

Firemangully 10-11-2012 12:39 AM

You might check the fuse box under the hood and make sure the ASD relay is good by swapping it with either the horn or AC relay. I had a horn problem recently and finally found out that it was a bad relay. It took me taking the ASD relay out to find out that the 13.00 part is crucial for the Jeep to start.

Good Luck!

Wattapunk 10-11-2012 07:06 AM

If you've already ruled out the battery and connections, I would pull the starter and take it to autozone for a free check. My guess is the starter from the issues you are experiencing.

s14sh3r 10-11-2012 09:14 AM

wrong thread

Buz 1 10-11-2012 02:21 PM

cable connections. turn on lights & try to start. if lights dim, bad starter is likely... if not, bad cable connections likely...:)

Fatherof2 10-11-2012 02:46 PM

my wiring running to my upper O2 sensor got too close to the exhaust down pipe and fused itself to it....Long story short, shorted out and popped a fuse...would not start. Removed short, replaced fuse, and no more problems...good luck

tallzdatank 10-11-2012 03:11 PM

neutral safety switch. im tellin you. usually a bad starter clicks. a bad neutral safety switch that wouldn't. it would act as though your trying to start it in "d" or "r"

Jerry Bransford 10-11-2012 03:18 PM

Try moving the shifter between Park and Neutral while holding the key in the Start position.

All times are GMT -5. The time now is 04:37 AM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.