I installed it myself and its no surprise to see I am 1/2" off. I have a vibration when turning but going straight I'm fine. I'm assuming this is a huge problem? I'm sure my tires aren't appreciating this. How do I get it to make up for the half inch it's an adjustable track bar won't an entire spin around again just make it a half inch the other way? Thanks in advance
10-23-2012 01:14 PM
One spin will only change the length the amount of the thread pitch about 1/16 of an inch.
10-23-2012 02:11 PM
What is your suspension lift height? You're saying you have run out of adjustment on the aftermarket adjustable length track bar to center your axle? With a typical height suspension lift, that is highly unusual.
10-23-2012 02:13 PM
When my tires were shaking in turns it was because of the alignment. Hope this helps.