Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   WF New Member Check In (http://www.wranglerforum.com/f12/)
-   -   Tranny Swap 99 Wrangler (http://www.wranglerforum.com/f12/tranny-swap-99-wrangler-203412.html)

Baker25 12-04-2012 09:53 AM

Tranny Swap 99 Wrangler
 
Hey guys here's the situation I've got, and help would be greatly appreciated.

My project started out as a 99 TJ 4.0 automatic to be driven daily/ wheeled. The tranny was weak from day one and I had a PO743 TCC code. I already had everything needed to do a 5 speed manual tranny swap which went rather smooth and it runs and drives perfect now with no issues. With that being said even after clearing the code 3 times I am still getting the PO743 Torque Converter Circuit Electrical code. The torque converter obv doesn't exist in my jeep anymore since the recent swap. Did I miss something when I plugged my harness back into the tranny and transfer, faulty fuse or relay, something I have to change to let the ECM know of the swap?


Thanks!

Beastmaster 12-04-2012 12:11 PM

Because this is the newbie check-in area, you may not get the answers you are looking for. I suggest you check out this area and post you questions there:

TJ Jeep Wrangler Forum - Jeep Wrangler Forum

In the mean time . . .

Welcome to the forum! :wavey:

_______
/l ,[____],
l---L -OlllllllO-
()_) ()_)--o-)_)

SilverSport 12-04-2012 02:49 PM

Welcome Aboard! :wavey:

dabolt55 12-04-2012 05:17 PM

Welcome, good luck with your issue...:thumb:

jokerchief462 12-04-2012 08:37 PM

Welcome to the forum and good luck on the swap!!!

kfdjason7620 12-04-2012 08:58 PM

Quote:

Originally Posted by Baker25 (Post 3065175)
Hey guys here's the situation I've got, and help would be greatly appreciated.

My project started out as a 99 TJ 4.0 automatic to be driven daily/ wheeled. The tranny was weak from day one and I had a PO743 TCC code. I already had everything needed to do a 5 speed manual tranny swap which went rather smooth and it runs and drives perfect now with no issues. With that being said even after clearing the code 3 times I am still getting the PO743 Torque Converter Circuit Electrical code. The torque converter obv doesn't exist in my jeep anymore since the recent swap. Did I miss something when I plugged my harness back into the tranny and transfer, faulty fuse or relay, something I have to change to let the ECM know of the swap?

Thanks!

I'm pretty sure your gonna have to get an ecm that's not programmed for the auto. But post this in the tj technical section and Jerry B. will answer it for you. I have read about this before

silver rubi 12-04-2012 09:21 PM

Welcome to the forum! Good luck with the issue. I recommend Jerry B as well.

MrSig 12-05-2012 04:13 AM

http://r23.imgfast.net/users/2314/13...3032514546.gif and enjoy the forum!


All times are GMT -5. The time now is 01:30 AM.