Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   JK General Discussion Forum (http://www.wranglerforum.com/f274/)
-   -   switch panels for a manual tranny (http://www.wranglerforum.com/f274/switch-panels-for-a-manual-tranny-219814.html)

Tuma 02-16-2013 11:39 AM

switch panels for a manual tranny
 
Im gonna do some exterior lighting and want to get a switch panel but its seems like with a manual tranny all I can get is the pillar switch panel. I saw that daystar only makes panels for auto trannys unless I wasnt looking good enough. I dont really wanna do pillar switches but will if I have to. Any suggestions?

skullnbeer 02-16-2013 11:41 AM

You can check out the sPOD unit.Not cheap but very nice.

4x4 SPOD Since 2005 - The ORIGINAL JEEP Over The Windshield Switch Console - Jeep Power Distribution System

Tuma 02-16-2013 11:43 AM

Quote:

Originally Posted by skullnbeer (Post 3376629)

Holy crap thats expensive

2five22 02-16-2013 11:45 AM

It is pricey, but it is absolute quality. It is frankly better in quality than OEM.

GlobalResponder 05-08-2013 08:18 AM

The Spod is overkill unless you're running on board air.

The Rugged Ridge and Daystar both make an A-pillar switch pod that isn't that bad. I will admit, the factory finish on them is pretty darn accurate to the OEM panels.
I didn't like the fit of my "Rugged Ridge" A pillar switch pod, but that is just me. I'm very picky and I just felt it is sloppy and not a perfect fit to my '10. Maybe it was really designed for newer JK's...don't know...

Good Luck!

HOOCBB 05-08-2013 08:34 AM

I'm in the same boat as the OP and looked at the sPOD, but it appears to be limited to 6 circuits, where I need 8 for my plans.

I'm planning on putting together my own relay/fuse panels to power the devices and should be able to stay under the price of the sPOD. I just can't figure out what to do with the other 4 switches unless I can mount them where the power window switches would have been.


All times are GMT -5. The time now is 01:31 PM.