Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ Tech Forum (http://www.wranglerforum.com/f210/)
-   -   sway bar link (http://www.wranglerforum.com/f210/sway-bar-link-219947.html)

Johnnybonkel 02-16-2013 09:05 PM

sway bar link
 
1 Attachment(s)
I want to change bottom sway bar link quick disconnects fr normal nut and bolt. Can you tell be torque setting for bolt and the size of nut and washer size. I ordered bolt and forgot to order nut and washer.

I have 2006 Rubicon. Thanks

Pink_Percy 02-16-2013 09:10 PM

Any 3/4 bolt, nut, and fender washer will work fine. Gorilla fist IS a torque spec.

andrew127 02-17-2013 06:43 AM

Tight. When I replaced mine I had to torch off the factory ones so I just used grade 8 half inch bolts, flat washers and a grade 8 lock nut. Just make sure when you install the bolts that you dont tighten them dont so much that you squash the link housing against the mount. If you still just want factory torque Id say call up your local Mopar service dept

Johnnybonkel 02-17-2013 09:16 AM

Quote:

Originally Posted by Johnnybonkel
I want to change bottom sway bar link quick disconnects fr normal nut and bolt. Can you tell be torque setting for bolt and the size of nut and washer size. I ordered bolt and forgot to order nut and washer.

I have 2006 Rubicon. Thanks

THANKS FOR THE REPLIES...THE TORQUE SPEC I FOUND FROM THE WORKSHOP MSNUAL SAY 70ft lbs
Thanks agan


All times are GMT -5. The time now is 01:03 AM.