Jeep Wrangler Forum

Jeep Wrangler Forum (
-   YJ Tech Forum (
-   -   leak (

jloza 02-19-2013 05:30 PM

hi every body i have a problem i have a 1989 jeep wrangler 4 cyl. i have a leak coming from between the tranny and engin block i belive its coming from the clutch slave cylinder in the trany so is this a comond problem and are they hard to replace do i need special tools what causes these to leak
thanks all

jokerchief462 02-19-2013 05:47 PM

On the 89 2.5 you can remove the inspection plate after you remove the starter to take a closer look. If it is brake fluid then slave cylinder which is internal and you will have to remove T-Case and Tranny. Might think about all the clutch at one time the slave comes with the rest of the clutch kit.

Only special tools needed are the starter bolts and possibly two bell housing bolts upper torqz.

Might want a tranny jack remove as one unit or split the T-Case and Tranny and put in new seals.

jloza 02-19-2013 05:59 PM

is it hard to remove the transfer case ?

jokerchief462 02-19-2013 06:04 PM

Not really biggest PIA is getting the shifter boot removed to get the two too linkage nuts off. Weighs about 45 pounds. Drain it first. Skid off support engine with jack and 2X4 across oil pan. The trans is heavy I have a tranny jack to old to mess with that anymore.

jloza 02-19-2013 07:44 PM

ok thanks i think ill just take it in and have it done i was quoted about 800.00

All times are GMT -5. The time now is 08:11 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.