So I go to replace my exaust and intake manifold gasket and apon reinstelation I went to tighten up the EGR tube and the damn threads were stripped before and of course I made them even worse trying to get it back on now I can't get it to start threading on either end and it's not even messed up on the intake sideI'm tempted to take it to the shop but figured I'd see if any of you have any advice or tricks to getting them back on
thanks for your advice I'll look into both the ideas and see witch one would work better I'm leaning towards the thread file
and thanks again guys
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ask a question
Ask a question
Jeep Wrangler Forum
9M posts
468K members
Since 2005
A forum community dedicated to Jeep Wrangler owners and enthusiasts. Come join the discussion about reviews, performance, trail riding, gear, suspension, tires, classifieds, troubleshooting, maintenance, for all JL, JT, JK, TJ, YJ, and CJ models!