Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   Builders Corner (http://www.wranglerforum.com/f118/)
-   -   Rear XRC armor intallation... help? (http://www.wranglerforum.com/f118/rear-xrc-armor-intallation-help-229836.html)

Pank-da-tank 03-23-2013 07:54 PM

Rear XRC armor intallation... help?
 
Was wondering if anyone had to do any trimming away at the wheel wells to get the smittybilt rear XRC armor to fit properly. I heard from a guy who said he had to do some cutting and I was wondering how much if any it would take to get a good fit.

XTRyan 03-25-2013 12:37 PM

Quote:

Originally Posted by Pank-da-tank (Post 3543690)
Was wondering if anyone had to do any trimming away at the wheel wells to get the smittybilt rear XRC armor to fit properly. I heard from a guy who said he had to do some cutting and I was wondering how much if any it would take to get a good fit.

Pank-da-Tank,

The Smittybilt XRC armor install is a very involved installation. They take a lot of time to get them to fit just right. I know a few guys who have installed them and said they were kind of complicated to install. As for trimming I don;t know if you will have to trim your Jeep or not. Here are the Installation Instructions right off of Smittybilt's site.

Hope this helps, shoot me a PM if you have any other questions!

-Zach


All times are GMT -5. The time now is 10:07 PM.