Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ Tech Forum (http://www.wranglerforum.com/f210/)
-   -   heater problem (http://www.wranglerforum.com/f210/heater-problem-23137.html)

hank1 11-13-2008 05:10 PM

heater problem
 
I checked the archives for this problem but have another question. My heater is blowing lukewarm at best. The thermostat is working correctly although it is a 185. The engine temp is just below 210 at the guage. I earlier flushed the engine and radiator with Prestone flush. At the same time I turned the heater on full hot so I assumed the core would be flushed also. There was a lot of rusty water in the engine. The heater did not improve.

Today, after a ten mile drive I felt the heater hoses. The hose coming from the thermostat housing, which I figure is the inlet hose, was hot as the radiator hose while the other wasn't nearly so. I don't see any vacumm lines or other devices attached to either hose. I think the easiest next step is to flush the core through the heater hoses and that brings me finally to my question.

Can I unhook the two hoses at the thermostat housing and wherever the second one attaches and backflush the core with a garden hose at low flow? If not, how would you folks recommend I do it? I've read as much about all of this as I can find but I still want to make sure. I haven't seen a write up on it. Maybe a stupid question but hey, I ain't the sharpest knife in the drawer.

slf41002 11-13-2008 05:31 PM

Yes you can unhook the heater hoses the other being at the water pump and flush the core with a garden hose.I would also check into a water pump since the coolant was rusty you have had some kind of metalic brake down to cause very much rust.A small amount maybe but very much at all and I would say you will find once removed that the water pump impeller will be almost gone.

Giancarlo 11-13-2008 05:35 PM

check ur heater core.. make sure its not leaking at all


All times are GMT -5. The time now is 09:12 AM.