Need help with pinion seal leak
95 2.5 stock Dana 35. I've been getting a leak out of the rear pinion seal.
So, first just did the seal. No better. So I thought maybe the yoke had a groove worn into it.
Did a new seal, yoke, crush sleeve, bearing. Felt a little loose on the pinion but much better. Still leaking.
Any ideas? New ring gear and pinion? Hoping to avoid if possible.
Suggestions/directions welcome ... Thanks folks
Anyone have a clue on this? Not leaking terribly, just a few large drops after a drive. Maybe 1/4 ounce of fluid on the driveway this morning. I would swap in a new axle but just swapped this one in a couple months back and was hoping to avoid doing it again lol
|All times are GMT -5. The time now is 08:42 PM.|
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.