Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   JK General Discussion Forum (http://www.wranglerforum.com/f274/)
-   -   Spiderwebshade (http://www.wranglerforum.com/f274/spiderwebshade-243030.html)

nobndry 05-16-2013 10:46 AM

Spiderwebshade
 
Howdy all,

Its time to put the shade in and i cant for the life of me figure out how to put it on. It came with the vehicle and i dont know how to put it on. Can someone show me a picture of it on from the outside and inside showing how it was attached?
Thanks!

SuperTJ 05-16-2013 10:50 AM

The black bungie cords feed through the eyelets and then hook around the roll bar and it loops around the ball. The middle one goes on the loop in the middle of the windshield.
http://ep.yimg.com/ca/I/allthingsjeep_2260_549194613

laollis 05-16-2013 10:51 AM

Hi, I had to ask too. The 3 small spiderballs go in the front, the spiderwebshade tag goes in the back, the remaining long spiderballs goes around the roll bars.

panthermark 05-16-2013 10:55 AM

Yup...the three small cords up front. The logo in back facing outwards....muddle through the rest. I went on Youtube and found videos.

laollis 05-16-2013 10:57 AM

Quote:

Originally Posted by panthermark (Post 3761724)
Yup...the three small cords up front. The logo in back facing outwards....muddle through the rest. I went on Youtube and found videos.

LOL, I always forget to check youtube. :banghead:

Thorshammer7 05-16-2013 11:30 AM

You are gonna love this thing. I did mine with all the balls to the inside. Short ones to the front. You will likely fiddle with it some and figure it out what works best. Pics when you are done !. :)

Utm18 05-16-2013 11:39 AM

Just install mine yesterday, so far real impressed with it

JeepHerz 05-16-2013 11:59 AM

Here are a couple of (dirty) photos. LOL.
On the front ones- closest to the doors-there is a groove in the roll bar that the bungee cord will fit into. Its a royal pain- you have to slide the cord under the black plastic piece- it will sit on the roll bar fabric. All while holding the ball on top.
Also- two will go through the soundbar. Ball on the inside- cord through the hole. Loop it around back to the ball.

drakenclimber 05-16-2013 12:40 PM

Quote:

Originally Posted by nobndry (Post 3761696)
Howdy all,

Its time to put the shade in and i cant for the life of me figure out how to put it on. It came with the vehicle and i dont know how to put it on. Can someone show me a picture of it on from the outside and inside showing how it was attached?
Thanks!

Here's a link to their instructional video:
SpiderWeb JKini Installation Instructions | SpiderWebShade.com

In a nutshell:
  1. Connect the front (small) spider balls first
  2. Connect the rear spider balls next
  3. Connect the side spiderballs last

nobndry 05-16-2013 05:24 PM

Thanks you guys! I finally got it on.

LoveJiuJitsu 05-16-2013 06:28 PM

Quote:

Originally Posted by nobndry (Post 3762998)
Thanks you guys! I finally got it on.

Awesome! Enjoy it. Seriously one of the best investments you can make for your Jeep.

LVCapo 05-16-2013 07:36 PM

Got mine today...I have to say awesome product and even better customer service/support. Would highly recommend.

skokie 05-16-2013 07:48 PM

Quote:

Originally Posted by Capper5016 (Post 3763394)
Got mine today...I have to say awesome product and even better customer service/support. Would highly recommend.

Agreed. Obtained the product 48 hours from ordering.

GTJ 05-16-2013 07:51 PM

I have been looking at these for the shade -how do they do at freeway speeds

LoveJiuJitsu 05-16-2013 07:57 PM

Quote:

Originally Posted by GTJ (Post 3763440)
I have been looking at these for the shade -how do they do at freeway speeds

Ours is perfectly fine on a JKU. Some have issues with flapping, but easily resolved from what I read.

GTJ 05-16-2013 07:59 PM

Quote:

Originally Posted by LoveJiuJitsu (Post 3763464)

Ours is perfectly fine on a JKU. Some have issues with flapping, but easily resolved from what I read.

Nice to hear thank you


All times are GMT -5. The time now is 05:21 PM.