Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   JK General Discussion Forum (http://www.wranglerforum.com/f274/)
-   -   jks qdisco too loose? (http://www.wranglerforum.com/f274/jks-qdisco-too-loose-245417.html)

Jeep757 05-27-2013 07:35 PM

jks qdisco too loose?
 
How tight can you really get them? I keep hearing this rattling sound in the front. I crawled under it and had my wife rock the jeep sideway and the bottom bolt moves up n down in the axle bolt hole. I've tried tightening it by putting a small screwdriver in where tge pin goes to hold it while I tighten the nut but is it that im just not tightening it enough or not worry about it

Barmanvarn 05-27-2013 07:52 PM

Quote:

Originally Posted by Jeep757 (Post 3798001)
How tight can you really get them? I keep hearing this rattling sound in the front. I crawled under it and had my wife rock the jeep sideway and the bottom bolt moves up n down in the axle bolt hole. I've tried tightening it by putting a small screwdriver in where tge pin goes to hold it while I tighten the nut but is it that im just not tightening it enough or not worry about it

I had the same happen to my TF set. I used blue loctite on them and tightened the crap out of them. No more issues.

mistasparkl 05-28-2013 11:56 AM

x2 Same happened to me until i really wrenched down on them. I was hearing a small popping noise in low speed turns.


All times are GMT -5. The time now is 03:59 PM.