Jeep Wrangler Forum

Jeep Wrangler Forum (
-   Communications and Electronics (
-   -   Key On Fuse (

C-Ron 06-07-2013 09:42 AM

Key On Fuse
Installed my bullydog this morning and used fuse M30- wiper motor frt, J1962 Diagnostic Feed. Everything worked as planned until I turned off the vehicle. For some reason the bullydog stays on. Any other suggestions for a good 10 or 15 amp key on fuse to use? Also what's a good way to run the wire into the fuse box where it doesn't get smashed once closed? I was thinking about drilling a small hole for the wire to go through but I'm afraid water will get in there. Any suggestions would be appreciated 👍

Ordiway 01-28-2014 04:51 AM

I'm doing this mod now as well! Have the same problem, I hooked it up to the window fuse and will not turn off! And how did you fix the pinched wire in the box? Any advice would be greatly appreciated!!

All times are GMT -5. The time now is 01:22 AM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.