Jeep Wrangler Forum

Jeep Wrangler Forum (
-   YJ General Discussion Forum (
-   -   Spare Tire Lock (

jhilley 01-06-2009 10:02 AM

Spare Tire Lock
I bought a 1991 Wrangler Renegade. It has the allow wheels and a wheel lock on the spare. There wasn't a key for the lock with the vehicle. I ordered a new one from the Jeep dealer, but it is too small to go over the lock. Does any one know the right part number for the key. The parts man said that this lock will work on the stud once I get the original lock off.

4point 01-06-2009 11:51 AM

I had locking nuts on all my wheels, I lost the key. I used some cheap 12 point sockets to remove them. I just drove them on with a hammer and removed the locks. Then I replaced them with normal lug nuts because I don't want to do that again.

whiteyj 01-06-2009 01:55 PM

Sounds like somebody added an aftermarket lock to the wheel. Options as above or grind some flats on the locking nut and wrench it off.

kvc123 01-06-2009 05:45 PM

Similar situation as jhilley. I had to have it ground down on the sides where an impact socket would grab, then wrenched it off. Scarred the inside of the lug hole though.

speepdaedeesi 01-06-2009 08:07 PM

go to a tire shop that sells rims.

they will have a key and you can loosen that one bolt to hand tight, then drive it home.

too easy.

onomea 11-10-2010 04:54 PM

Aloha, I used the info from member jeepsR4me19 and got the lock off in less than a minute. Thanks for the info on socket size(3/4inch).

MikeMTJ 11-10-2010 06:41 PM

I'm in the same boat here. I'm going to try and get it off this weekend. I'll let you know what works.

All times are GMT -5. The time now is 11:57 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.