Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ General Discussion Forum (http://www.wranglerforum.com/f282/)
-   -   3" lift + mmL = cv driveshaft needed? (http://www.wranglerforum.com/f282/3-lift-mml-cv-driveshaft-needed-24945.html)

Warpman89 01-09-2009 09:57 AM

3" lift + mmL = cv driveshaft needed?
 
i would like to get a 3" lift that uses the stock control arms, and a 1" body lift to get 4" lift total. if i install a 1" motor mount lift would i need a cv driveshaft?

mr4x4 01-09-2009 11:06 AM

NO


I had a 3" tera flex basic lift kit and no 1" body lift and 33's I didnt even have the motor mount lift and I had no vibes

Warpman89 01-09-2009 11:42 AM

thank you

1BLKJP 01-11-2009 01:26 AM

I agree with Mr 4x4. Odds are you won't have vibes with that setup. However if you do just put the TCase drop in that I'm sure the lift provides and you should be fine. I would suggest you not put it in right away though. Put all of your suspension/body lift etc.... in and then test drive to see if you have any vibes.

orange05tj 01-11-2009 07:26 AM

i run 3" lift, 1" bl and love the setup. I do have the mml, but I installed it before I did the suspension lift. I did need a tcase drop. I dont have a Rubicon, so you might be fine without it.


All times are GMT -5. The time now is 12:45 AM.