Jeep Wrangler Forum

Jeep Wrangler Forum (
-   YJ Tech Forum (
-   -   Intake help! (

Vstrefling 06-27-2013 09:46 PM

Intake help!
I just got feed up with the original carb and went with a new Weber. Every time I thought it was running good just give a day or two and the rough idle to no idle, rough start... Freaking just had enough. In the process of taking carb off I decided to put a aluminum head cover on and get the intake and exhaust manifolds sandblasted. My question is when I put everything back together tomorrow what do I need put back on the intake? I've done a nutter and just want to clean things up a bit! There was a lot of sensors that didn't have anything running to them. Plus there was a red wire cut off coming from the bottom of the intake. It goes into where the center piece with the cones shape things are... Sorry that's the best way I could describe it.

Any help would be appreciated I just want to do the jeep thing this weekend!

roadyrob 06-28-2013 07:01 AM

its the manifold heater. if you disconnect it your jeep may run alittle rough until warm in cold weather. its really not needed, my offenhauser manifold doesn't have it.
the only things on my intake are the water inlet and outlet, vacuum for the brake booster, and vacuum on the rear of the manifold for the heater. if you run the cto valve you will need that too.

Vstrefling 06-28-2013 09:20 PM

Thank you for your response!

All times are GMT -5. The time now is 06:50 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.