Jeep Wrangler Forum

Jeep Wrangler Forum (
-   JK General Discussion Forum (
-   -   Axel shaft replacement! (

Powderburn 07-10-2013 10:07 AM

Axel shaft replacement!
I will be upgrading my front shafts with a set of G2 shafts today! Any pointers on how to do this would be great! . I have seen videos and I recently changed my ball joints so I have a pretty good idea how to do it. But any advice would be sweet.

kjeeper10 07-10-2013 11:16 AM

4351 Attachment(s)
Same procedure as the ball joints pretty much. Going to need a 36mm socket for the hub nut.

RemoJK 07-10-2013 12:29 PM

YEa if you did the ball joints already you should be fine.
I have seen someone put a socket behind the hub and turn the wheel to loosen it up instead of beating it with a hammer. Can't remember where though

WatchThis! 07-10-2013 12:34 PM

Easy enough to do. A swivel 12point 13mm makes it easer to take the unit bearing off. But since you have done the ball joints already you have got it covered.

Hour, hour and half job.

All times are GMT -5. The time now is 05:58 AM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.