Jeep Wrangler Forum

Jeep Wrangler Forum (
-   YJ Tech Forum (
-   -   Another brake line question. (

kvc123 02-16-2009 02:19 PM

Another brake line question.
I have a hole in the line that runs from the master cylinder to the rear. Trouble is it is right at the support bracket on the frame where the line goes from steel to rubber. The rubber then runs to the T block on the axle.
Everything is locked up tight with rust at the bracket and I can't get the clip loose that holds the line in the bracket.

Has anyone re-routed the brake line and bypassed this bracket?
Any suggestions?
Also...what size is the brake line on a 94 YJ?

trumsey07 02-16-2009 05:18 PM

spray the hell out of it with pb blaster and you will be better off replacing the whole set up from hard to soft line i did and i replaced it with a braded steel line and the break line is 3/16

kvc123 02-17-2009 06:30 AM

ok thanks trumsey07, I did spray the dog s**t out of it.
She is on there purdy dern good.

trumsey07 02-17-2009 10:06 AM

once you spry it down let it sit for like 20mins. then take a hammer and try tapping the clip to see if it will break loose. I had to actually put wrench on one sie of the bracket and a vice grip on the soft line and break the hard line off. once it broke off i was able to hit the soft line out of the bracket.

kvc123 02-17-2009 05:56 PM

I got it. Pain in the ass but I got it. Now just got to find a replacement.
Thanks for the help.

All times are GMT -5. The time now is 03:59 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.