I have a 1991 Jeep Wrangler with a 5speed 6cylinder 4wd and I was driving home and went to shift from 5th to 4th gear and it got stuck in 4th and will not come out the shifter is hard and will not move any where? I have no idea about these transmissions or what type it is except it is a stock 1991 jeep wrangler. The Jeep does drive and move. I took the shifter off and looked down in the hole but all you see is a big rod and a square with a circle in it i assume the shifter goes through to shift. I dont see any plates or openings other then that to look inside at the linkages or anything. Any help anyone can give me or some information on the transmissions in these would help a ton. Also is there any other vehicles that have this transmission so I can goto the junk yard and maybe find one.
04-06-2009 07:51 AM
I'm assuming that the clutch is working? Disengages the engine when the peddle is pushed in?
04-06-2009 03:39 PM
yes the clutch works fine
10-19-2010 01:50 AM
I had this same problem 2 years ago and my synchros were done. I had to have my tranny rebuilt. Sucks, sorry.
10-19-2010 02:33 AM
X2 bad synchros. Try forcing it in to neutral my bro had this same problem and that's what he did and it workes fine now.
10-19-2010 09:42 AM
I had a four cylender do the same thing I ran it low on gear oil have u cheaked it there is a screw in plug on the side of tranny I ended up taking a hammer an pushing my clutch an wooping it outa gear lmao it worked tho but I wouldn't advise that u could mess it up I didn't care cause I was bout to do a engine an trans swap