Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ Tech Forum (http://www.wranglerforum.com/f210/)
-   -   Bump stops for the stock spare carrier (http://www.wranglerforum.com/f210/bump-stops-for-the-stock-spare-carrier-42586.html)

GA_TJ 01-11-2010 08:57 AM

Bump stops for the stock spare carrier
 
I've got a 32" tire on the factory spare carrier and I'm looking to get some larger bump-stops to help it seat properly. I can't seem to find what I'm after on quadratec/google. Anyone have a link for these or a cheap/easy, decent looking way to fabricate your own?

Neil F. 01-11-2010 09:33 AM

I need to push mine out about 3/4 - 1". Hockey pucks behind the factory rubber worked perfect. I forget what the metric thread is but I got the longer bolts from Pep Boys.

4Jeepn 01-11-2010 09:34 AM

Hockey pucks perhaps.. cut them to match the stock spacer and then, get longer bolts.. Or they do make an extender that bolts to the stock carrier.. though that places more stress on it and tends to bust is sooner..

bobjenkins 11-16-2010 06:52 PM

Someone had a good idea of getting a rubber mallot and putting that between the tailgate and stock bump stop then just get longer screws. Im going to try it tomrrow

Neil F. 11-16-2010 07:36 PM

Buying 5 mallots? Hockey pucks are cheaper.

bobjenkins 11-16-2010 07:38 PM

Quote:

Originally Posted by Neil F. (Post 880088)
Buying 5 mallots? Hockey pucks are cheaper.

I dont know where to buy pucks, wheres a place to get em? how much are they? ... they do seem like a better idea but I need about 1.75 inches not sure how thick they are

damn they are cheap on amazon 1.26 Im going to get some thanks!!

UnlimitedLJ04 11-16-2010 07:41 PM

x3 on hockey pucks. get em from Play-It-Again sports, like 50 cents each.

Neil F. 11-17-2010 04:21 PM

You can get them from any local spoorting goods stoore. Sport Authority, Dicks.... etc. Hockey pucks are 1" thick. What kind of rims or backspacing do you have? Your rims are 1.75" off of the stock snubbers?

Gary2 11-17-2010 05:16 PM

I cut down a few of the accordion looking rubber bumpers sold on Qtec then drilled through them for bolt and then a larger hole part way through it to counter sink the mounting bolt. I them mounted them to the tail gate and trimmed off what was needed to fine tune the length. I think the bumpers were actually for a JK spare tire .It was cheap and it looked OE


All times are GMT -5. The time now is 09:21 PM.