Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   Help just replaced my transmission (http://www.wranglerforum.com/f218/help-just-replaced-my-transmission-44918.html)

cpaul3 02-21-2010 06:02 AM

Help just replaced my transmission
 
Any idea?? i swapped out my 5 speed transmission yesterday and now my jeep will not start.

thanks CP

Screwjack 02-21-2010 07:03 AM

What is it doing? Does it attempt to turn over and then nothing, or the starter turns and turns but doesn't catch, or is it more like no power and the starter doesn't even turn?

cpaul3 02-21-2010 08:35 AM

ok it turns over and over sounds like it is not getting gas... if i turn the engine over without the clutch in it pulls so i know the clutch is engaged but i didnt do anything but swap out the transmission.
thanks
Cp

Screwjack 02-21-2010 09:14 AM

I replaced a transmission recently, so let me think about it a bit and see what I can't come up with. In the mean time, somebody else on the forum that knows more than me will probably be along shortly with an answer.

cpaul3 02-21-2010 11:48 AM

well anything will help it was jacked up for 12 hours and i hope it will start today after it sat overnite. i didnt disconnect the battery someone said it might have a reset switch somewhere i need to reset ??????? i dont know thats why im asking

thanks CP

jpdocdave 02-21-2010 11:53 AM

most common culprit here is the crank position sensor, either did not get plugged back in, or wires got pinched between the trans and engnie. the sensor is toward the top of the bellhousing, and gets overlooked.

cpaul3 02-21-2010 12:34 PM

cool ty ty ty

cpaul3 02-21-2010 04:33 PM

its not the sensor looks to be the fuel pump i took off the fuel filter turned on the keys and nothing no fuel moving...

thanks
CP

jpdocdave 02-21-2010 04:48 PM

well make sure you have power and ground at the pump before condeming it.

Garyk 02-21-2010 08:41 PM

Quote:

Originally Posted by jpdocdave (Post 552206)
well make sure you have power and ground at the pump before condeming it.

x-2, that's too much of a coincidence to have that problem after being under the Jeep

jpdocdave 02-21-2010 09:20 PM

http://mybroadband.co.za/photos/data...fdsfsdfpr6.jpg

i just wanted to use that.

Abomination93 02-21-2010 10:21 PM

fuse for the pump, relay for the pump, bad ground. i like checking easy stuff first like fuses and relays.


All times are GMT -5. The time now is 07:29 PM.