Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ Tech Forum (http://www.wranglerforum.com/f210/)
-   -   Axle ID (http://www.wranglerforum.com/f210/axle-id-61647.html)

Ray - San Jose 09-13-2010 06:27 PM

Axle ID
 
How can I tell what axle shafts are in my '02?

I know I have a 30 front, and a 44 rear with TracLoc, both in 3:73. I want to order a set of OX lockers for when I convert over to 4:56. but I'm not sure which axles are in there. OX lists either 27 or 30 spline for the Dana 30, and either 30 or 33 spline for the Dana 44. My build sheet sheds no light on the matter, and the FSM doesn't help either.

Thanks folks

'02 Sport 4.0L 5sp D30/D44

doughenry 09-13-2010 07:35 PM

should be 27 in the dana 30 and 30 spline in the 44,but if your going to upgrade to the ox lockers in my opinon you should upgrade your axles to alloy and bigger spline much stronger.I have the ox and it is worth every penny

Ray - San Jose 09-14-2010 06:08 PM

This forum is slipping, 50 views in 24 hours, and only 1 response.

doughenry 09-14-2010 07:20 PM

What else do want to know? if your going for strength go with 30spline alloy in the dana 30 as for the 44 go 33 spline alloy.If its stock the 30 should have 27 spline 44 should have the 30 spline stock

Ray - San Jose 09-14-2010 09:50 PM

I was hoping for a couple people to say the same thing so I would have a warm fuzzy feeling about my being correct in ordering $1500 worth of lockers. Not saying you're not correct mind you, just saying I like the warm fuzzies.

4Jeepn 09-14-2010 09:57 PM

yes what he said 27 and 30 splines.. do you feel more warm and fuzzy now?

Ray - San Jose 09-14-2010 10:20 PM

Getting warmer and fuzzier


All times are GMT -5. The time now is 10:28 PM.