Jeep Wrangler Forum

Jeep Wrangler Forum (
-   TJ General Discussion Forum (
-   -   Body Lift Question (

jherrin215 04-03-2007 02:33 PM

Body Lift Question
I am going to be installing a 1 inch performance Accessories Body lift this weekend as well as a JKS motor mount lift. I was wondering if anyone knew where there was a good write up about a similar installation that i could look at. The body lift has instructions and the MML has instructions but I know there will be some steps on the BL I don't have to do using the MML. I found this---> and it uses a LOT less steps than the instructions with the BL but doesn't use a MML. Is it as simple as what he says or do I need to go through all the steps that they show in the BL instruction booklet?? Thanks

1BLKJP 04-03-2007 04:32 PM

Doing the motor mount lift you are going to be able to skip moving the fan shroud and more than likely the linkage. Just add in your MML and then you BL and see how the linkage feels. Everything else you won't need.

binaryking 04-03-2007 09:32 PM

yeah the fan shroud is really the only thing you HAVE to do when installing only a 1"BL. And with the MML, you can skip it.

NalinMFG 04-03-2007 10:02 PM

are there any write ups for a MML? i understand where they go and how they go there.... but i like pictures

Triple88a 04-03-2007 10:54 PM

i believe although you are installing mml and bl you still have to disconnect the fan shroud unless you are doing the bl and the mml at the same second 4th by 4th lol

jherrin215 04-03-2007 11:44 PM

Thanks, that's what I was hoping. I was going to do the MML 1st then do the BL as soon as I got done. So the only things I should really have to do are, Do the MML, Then Just loosen the Body mounts on both side, remove one side, jack it up, put in the blocks, hand tighten 1st side, then jack up 2nd put in pucks and then tighten all the bolts right?? If it is like I think should be easy enough!!

RedRubiTJ 04-04-2007 12:12 AM

Yes. The order you have is good just don't start the engine until both are completed as the fan will hit the shroud. Leave enough slack in the "hand tightend" side to allow for movement when doing the other side.

erickpl 04-04-2007 07:11 AM

JKS spacer motor mount lift

jherrin215 04-04-2007 01:35 PM

Thanks for that link eric, that should really help me out!!

erickpl 04-04-2007 01:49 PM

NP. Glad to help.

Triple88a 04-04-2007 05:35 PM

any one have a blueprint of a motor mount lift spacer?

erickpl 04-05-2007 07:34 AM

Aluminum block 1" thick.

2 holes. :)

jherrin215 04-05-2007 10:40 AM

That's about the jist of it. They come with stud extenders and bolts and that's it. Pretty simple setup really.

All times are GMT -5. The time now is 08:22 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.