Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   TJ General Discussion Forum (http://www.wranglerforum.com/f282/)
-   -   Replacing wheel studs... (http://www.wranglerforum.com/f282/replacing-wheel-studs-76069.html)

wavebacktothetj 01-16-2011 01:06 AM

Replacing wheel studs...
 
I have some cross threaded studs on my 04 and I was told by 4wheelparts that for the rear you have to remove the axle shaft and in the front the hub has to come off, is this true? I really don't have the time to mess with this has anyone replaced Jeep studs, and if you had it done how much did it cost you thank you!

jasonwrangler 01-16-2011 01:20 AM

for the rear you just smack till it comes out, remove drum first.
the front I heard if you remove rotor and caliper you should have enough space.

JAX-SRF 01-16-2011 06:17 AM

This is a great question! I currently have a bent stud on the front and was thinking about replacing it myself. It is not bent so bad that I can't remove and replace the wheel. However, I know it's bent, ya know.


All times are GMT -5. The time now is 08:32 PM.