Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   JK General Discussion Forum (http://www.wranglerforum.com/f274/)
-   -   2011 JK 2 Door Passenger Door Rattle (http://www.wranglerforum.com/f274/2011-jk-2-door-passenger-door-rattle-80738.html)

raffijeep 02-17-2011 03:06 PM

2011 JK 2 Door Passenger Door Rattle
 
Hearing a rattle in the passenger side door which doesn't always happen. Normal bumps, nothing. But certain types of bumps cause a rattle.

Anyone else having this issue? Taking it to the dealer but wanted to start a thread to see if anyone else has been dealing with the same thing.

jeffk42 02-17-2011 03:45 PM

I don't have it with my full steel doors, but my driver side Bestop tube door has a small amount of play in the latch, causing a rattle over bumps which I solved by adding one layer of electrical tape on the loop that the latch comes in contact with.

raffijeep 02-17-2011 03:53 PM

Thanks Jeff. I'll try that out to see if that's where it's coming from.

KBR97 02-17-2011 05:41 PM

I used the electrical tape fix too...I did it on all 4 doors of the JKU, worked perfectly. You may need a few wraps with the tape or just on may do it.

kawasakizx636 02-17-2011 05:47 PM

A lot of people have this issue, myself included. Electrical tape works wonders :) Some people have corrected it by adjusting the striker.

chucky cheese 02-17-2011 06:39 PM

Had a rattle. Found those knobs on the roll cage were loose. Tightened them up and rattles stopped.

MHDSahara 02-17-2011 10:33 PM

I had the same exact rattle. Right in (below?) the passenger side door. I took it into the dealer and they fixed it in pretty short order. I actually was taking it in to have them fix the astrostart - about 10% of the time it would set off my "panic" button - and had them look at the door at the same time. Both problems fixed within a couple hours.

Kaisoboy 11-25-2011 07:03 PM

Had the same rattle on my passenger door. Found a thread on another forum that said to adjust the U striker 1/8" inward toward the seat. I loosened the two striker bolts, made the adjustment and whalla! The rattle is gone!

Cheers


All times are GMT -5. The time now is 10:34 PM.