Jeep Wrangler Forum

Jeep Wrangler Forum (http://www.wranglerforum.com/)
-   YJ Tech Forum (http://www.wranglerforum.com/f218/)
-   -   Help with Wire and Vacuum Lines (http://www.wranglerforum.com/f218/help-with-wire-and-vacuum-lines-81501.html)

mcguirjf 02-22-2011 12:51 PM

Help with Wire and Vacuum Lines
 
4 Attachment(s)
Greetings,
1. I need help in finding where this blue with white strip wire goes. It runs in the wiring loom between the carb and cylinder head.

2. The next is a T fitting that is located on a vacuum line that runs between the cylinder head and fire wall.

3. The final is two vacuum lines located near the passenger side frame rail. I have a blue line that goes no where, and a brown or green line that has a rubber fitting on the end and I can't find where it goes.

I'm currently rebuilding the Carter BBD 8384 carburetor.

Any help is appreciated!
Thanks again:wavey:

mcguirjf 02-22-2011 07:07 PM

I believe I found where the broken blue wire with white strip goes. There is a sensor that is threaded into the intake manifold just forward of the carburetor mount location. Any idea what this sensor is? Intake air temperature?

Garyk 02-23-2011 02:32 PM

Most likely Mass Air Temp

mcguirjf 02-24-2011 09:27 AM

Found that Autozone has an online repair manual. Cool.

That wire goes to the knock sensor that is screwed into the intake manifold just forward of the carburetor.

Now I just have to findout those two vacuum line issues.


All times are GMT -5. The time now is 07:44 PM.