Jeep Wrangler Forum

Jeep Wrangler Forum (
-   JK General Discussion Forum (
-   -   windshield mounted lights install (

Armadaskier 06-03-2011 12:41 PM

windshield mounted lights install
I tried searching for a write-up on how to install lights and brackets on my windshield of my 2010 JKU, but found nothing. If anyone had a detailed set of instructions or know where to find a write up I would greatly appreciate it. I want to know how much is involved before I buy a set and try installing them myself. Thanks.

JIMBOX 06-03-2011 12:52 PM

:D The physical installation is 15 minutes no matter who makesem and they only go on one way, LEFT/RIGHT -the windshield bkts are self explanatory and the wiring instructions will come with the mfg package-ie KC/PIAA/HELLA/Polaris/RookRiders/RudggedRidge--

Google it

Good luck

:dance::rofl: JIMBO

smaxberry 06-03-2011 12:59 PM

You have to undo the torx screws on the bottom corners of the windshield, I used a Allen wrench. Some people cut a piece of rubber to use as a gasket to prevent scratching, I did not. Then hang back up with the torx screws you took out.

2010WranglerMountain 06-03-2011 02:35 PM

by far the easiest thing to do....the only part you have to think about and figure out how YOU want to do it is run the wiring harness...from start to finish, light brackets, lights, and harness, no more than an hour or two.

All times are GMT -5. The time now is 09:53 AM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.