Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 66
Search took 0.10 seconds.
Search: Keyword(s): ; Posts Made By: PRS
Forum: JK Tech Forum 11-16-2014, 05:19 PM
Replies: 15
Views: 484
Posted By PRS
All I did was re-install the stock tune and MAP...

All I did was re-install the stock tune and MAP sensor. Blower was still blowing but at low RPMs doesn't make much difference. It will run ok as long as you don't get into the boost range(higher than...
Forum: JK Tech Forum 11-16-2014, 04:50 PM
Replies: 15
Views: 484
Posted By PRS
With the stock tune and the stock MAP the mixture...

With the stock tune and the stock MAP the mixture will initially be rich since you are using larger injectors, but it should start and run ok as long as you don't exceed ambient MAP. The stock MAP...
Forum: JK Tech Forum 11-16-2014, 04:28 PM
Replies: 15
Views: 484
Posted By PRS
13.77 is 1 psi less than sea level absolute so...

13.77 is 1 psi less than sea level absolute so I'm guessing it's close for your location today. I'm at 5600 feet altitude and my MAP is 11.78 psi today.
My Ripp MAP sensor reads 700 ohms 1&2, 300...
Forum: JK Tech Forum 11-16-2014, 03:36 PM
Replies: 15
Views: 484
Posted By PRS
Sounds like what happens with the stock tune and...

Sounds like what happens with the stock tune and the Ripp MAP sensor. Need to make sure the new tune is writing to the PCM.
I would write the stock tune with the stock MAP sensor installed. Start...
Forum: JK Tech Forum 10-15-2014, 10:12 PM
Replies: 358
Views: 34,698
Posted By PRS
What codes?

What codes?
Forum: JK Tech Forum 09-12-2014, 04:37 PM
Replies: 3
Views: 592
Posted By PRS
That's the camshaft position sensor. It has an...

That's the camshaft position sensor. It has an o'ring seal on the bolt and a press in seal around the outer diameter. You can probably change the bolt o'ring without disturbing anything. If it's the...
Forum: JK Tech Forum 09-03-2014, 10:16 AM
Replies: 358
Views: 34,698
Posted By PRS
Question My belt only squeals initially when cold and I...

My belt only squeals initially when cold and I try to turn the steering wheel fast.
I kinda like the blower whine.
I have the same issues as JeepOUray with the initial sputtering only during the...
Forum: JK Tech Forum 09-01-2014, 08:56 AM
Replies: 358
Views: 34,698
Posted By PRS
What issue do you have?

What issue do you have?
Forum: JK Tech Forum 08-23-2014, 01:00 PM
Replies: 358
Views: 34,698
Posted By PRS
Mishimoto has a radiator with 60% more area. That...

Mishimoto has a radiator with 60% more area. That might be enough to do the trick. Pricey though.
Forum: JK Tech Forum 08-17-2014, 05:44 PM
Replies: 12
Views: 2,246
Posted By PRS
Most require the engine off but the key on, not...

Most require the engine off but the key on, not ACC.
Forum: JK Tech Forum 07-29-2014, 12:18 AM
Replies: 358
Views: 34,698
Posted By PRS
I don't know that there's room for a larger one....

I don't know that there's room for a larger one. As you recall we had to modify the fan struts the way it is.
Forum: JK Tech Forum 07-26-2014, 08:58 AM
Replies: 358
Views: 34,698
Posted By PRS
Did a camping run to Deep Lake 2 weeks ago. Going...

Did a camping run to Deep Lake 2 weeks ago. Going East up Vail Pass temp was 3/4 on the gauge. Pulling a 3000# camper. Hard pull. 4500 RPM in third gear for a long time. Same thing Going east up to...
Forum: JK General Discussion Forum 05-26-2014, 11:30 PM
Replies: 4
Views: 431
Posted By PRS
Oil filter for 2014

Make sure you didn't get a filter for a 2014. Several folks have had this issue. The filters are different and will cause low flow.
Forum: JK General Discussion Forum 05-18-2014, 12:33 AM
Replies: 0
Views: 261
Posted By PRS
Slush on LED headlights

I installed some Kc Highlites LED headlights a month ago. Over mother's day we had wet snow and low 30 temps. The headlights had a nice coating of slush on them since the LEDs don't generate enough...
Forum: JK General Discussion Forum 05-18-2014, 12:02 AM
Replies: 138
Views: 14,112
Posted By PRS
ElToro is your coolant still 3-4 inches low in...

ElToro is your coolant still 3-4 inches low in the radiator with a high level in the overflow? I had the pick-up tube in the overflow fall off the nipple in the cap. Coolant was always high in the...
Forum: JK Tech Forum 04-15-2014, 04:30 PM
Replies: 19
Views: 547
Posted By PRS
I'm thinking since they are LED they will...

I'm thinking since they are LED they will probably work on just the 12VDC. Most LEDs have a broad voltage range where they will work.
Forum: JK General Discussion Forum 04-08-2014, 02:41 PM
Replies: 44
Views: 6,371
Posted By PRS
We should all have such problems.:)

We should all have such problems.:)
Forum: JK Tech Forum 03-23-2014, 11:15 PM
Replies: 358
Views: 34,698
Posted By PRS
RIPP has been working on the tune. I still have...

RIPP has been working on the tune. I still have some issues and up until this latest tune was still getting P2097 CELs. Have had the tune installed for about 5 days. They have turned down the pep...
Forum: JK Tech Forum 02-20-2014, 12:23 AM
Replies: 358
Views: 34,698
Posted By PRS
We were a group of Ripped Wranglers that had some...

We were a group of Ripped Wranglers that had some issues and needed to know if there were others. Come to find out there were quite a few of us, which I think is kind of the intent of forums like...
Forum: JK Tech Forum 02-14-2014, 03:38 PM
Replies: 358
Views: 34,698
Posted By PRS
Thumbs up Just a little update. Have been back & forth with...

Just a little update. Have been back & forth with Ripp over the last couple days. They think they have found some things and have sent me some new tunes. At least initially my backfiring issues have...
Forum: JK Tech Forum 02-13-2014, 10:33 AM
Replies: 358
Views: 34,698
Posted By PRS
Yeah, but once we get the bugs worked out it'll...

Yeah, but once we get the bugs worked out it'll be super. Just a matter of time.
Forum: JK Tech Forum 02-12-2014, 06:52 PM
Replies: 358
Views: 34,698
Posted By PRS
Once you install a blower, there is no engine and...

Once you install a blower, there is no engine and drivetrain warranty.
Forum: JK Tech Forum 02-12-2014, 10:53 AM
Replies: 358
Views: 34,698
Posted By PRS
So, what time period are we talking about where...

So, what time period are we talking about where the tools and the updates are suspect?
Just spell it out so everyone will know if they should question the integrity of the process.
Why does this...
Forum: JK Tech Forum 02-12-2014, 10:12 AM
Replies: 358
Views: 34,698
Posted By PRS
So what is the time period where there was an...

So what is the time period where there was an issue with the tool? Why do you keep wanting us to take this off the forum? As 3240 said, if you have 350 kits out there, I'm sure not everyone has...
Forum: JK Tech Forum 02-11-2014, 07:26 PM
Replies: 358
Views: 34,698
Posted By PRS
In other words take it off the forum because this...

In other words take it off the forum because this is bad for sales.
I installed my kit in late September and had numerous CELs both rich and lean, O2 sensor codes and BACKFIRING when open loop. I...
Showing results 1 to 25 of 66

 
Forum Jump

All times are GMT -5. The time now is 11:51 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC