Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 68
Search took 0.12 seconds.
Search: Keyword(s): ; Posts Made By: Jeepn Again
Forum: TJ General Discussion Forum 02-13-2013, 05:45 AM
Replies: 46
Views: 3,064
Posted By Jeepn Again
I used the write up on 4x4xplor.com as a guide....

I used the write up on 4x4xplor.com as a guide. It's a write up on the budget boost install, but exact same principle with springs instead of spacers.
Good luck! A couple hints - use lots of PB...
Forum: TJ General Discussion Forum 12-12-2012, 11:08 PM
Replies: 42
Views: 1,530
Posted By Jeepn Again
That's a really good deal. Around here that would...

That's a really good deal. Around here that would sell for $16-18k. I even did the conversions to see what the real numbers were!:rolleyes:
Buy it. I'd rather have the LJ, but can't find the right...
Forum: TJ General Discussion Forum 12-04-2012, 11:33 PM
Replies: 22
Views: 3,630
Posted By Jeepn Again
Mine was out 3/4" after just a 2" lift (new...

Mine was out 3/4" after just a 2" lift (new coils). Good lesson for all that alignments should be performed even after the smallest of lifts.
Forum: TJ General Discussion Forum 12-01-2012, 09:33 PM
Replies: 6
Views: 499
Posted By Jeepn Again
I have owned two 2.5L TJs, both on 31" MT/R tires...

I have owned two 2.5L TJs, both on 31" MT/R tires with the stock 4.10 axle gearing and 5-speed transmissions. They did fine on the highway, with only occasional 4th gear use required for steep...
Forum: TJ General Discussion Forum 11-30-2012, 11:46 PM
Replies: 10
Views: 508
Posted By Jeepn Again
Hard top, soft top, Dana 44 rear axle, a/c...

Hard top, soft top, Dana 44 rear axle, a/c working, axle ratios, rust?? Lots of variables. But in general, it could be a decent deal, but not a steal with leaking fluids. Don't jump on it without...
Forum: TJ General Discussion Forum 11-29-2012, 10:47 PM
Replies: 15
Views: 729
Posted By Jeepn Again
I put 31x10.5s on my factory wheels. Rubbed on...

I put 31x10.5s on my factory wheels. Rubbed on the arms. Did the washer trick. Hated the lost turning radius so I switched to the wheel spacer trick. Just went with the minimum 1" spacers. Did the...
Forum: TJ General Discussion Forum 11-25-2012, 09:06 AM
Replies: 25
Views: 1,247
Posted By Jeepn Again
Dang, I'd almost think about driving to Cinci for...

Dang, I'd almost think about driving to Cinci for that first one. That would sell in a few hours here. I'm soooo tempted....

I gave up looking for a 6 cylinder right away. Bought a super clean 2.5...
Forum: TJ General Discussion Forum 11-24-2012, 01:03 AM
Replies: 23
Views: 935
Posted By Jeepn Again
In response to the question how much can your...

In response to the question how much can your speedo be off - mine is off 9%
I only went from stock tires to 31's. I just figure 10% for easy math. Example: speedo says 30, actually going 33. Says...
Forum: TJ General Discussion Forum 11-23-2012, 06:17 PM
Replies: 5
Views: 609
Posted By Jeepn Again
I installed 1" spacers on my stock 7" wheels with...

I installed 1" spacers on my stock 7" wheels with 31x10.5 tired so I could remove the washers from the steering stops. I regained my full turning radius again. My tires were rubbing prior to...
Forum: TJ General Discussion Forum 11-22-2012, 06:36 AM
Replies: 10
Views: 356
Posted By Jeepn Again
I sold my wrangler way back when I went to...

I sold my wrangler way back when I went to college. Had it for a short time while at school, but it was a 2 hour drive and soft top. After doing that trip a few times, I sold it and bought a full...
Forum: TJ General Discussion Forum 11-20-2012, 10:46 PM
Replies: 45
Views: 2,127
Posted By Jeepn Again
I've come to realize its not a matter of...

I've come to realize its not a matter of preference of engine or power. Every single person on here would prefer the 4.0 over the 2.5 or 2.4 including myself. The real difference is budget! They both...
Forum: TJ General Discussion Forum 11-19-2012, 10:39 PM
Replies: 17
Views: 1,147
Posted By Jeepn Again
I'm a big fan of lower miles on older cars versus...

I'm a big fan of lower miles on older cars versus newer cars with higher miles for the same price. Or even higher prices in some cases! Especially if it's the same model vehicle. Only if you know...
Forum: TJ General Discussion Forum 11-17-2012, 07:31 PM
Replies: 42
Views: 1,065
Posted By Jeepn Again
That's a pretty good price for our area on the...

That's a pretty good price for our area on the red jeep with the full doors, a/c and hard top. IF the rust is non existent. If it's rusty, pass. Don't buy someone else's problem. You can sell the...
Forum: TJ General Discussion Forum 11-17-2012, 05:59 PM
Replies: 42
Views: 1,065
Posted By Jeepn Again
That's funny. I drive past that jeep every day....

That's funny. I drive past that jeep every day. At least for as long as its been on the lot. It looks clean. The only reason I didn't stop was because of the half doors. I prefer the full for our...
Forum: TJ General Discussion Forum 11-17-2012, 12:18 AM
Replies: 16
Views: 1,104
Posted By Jeepn Again
I ended up with the 4 cylinder because of my...

I ended up with the 4 cylinder because of my jeep's overall excellent condition otherwise. It's the 2.5, manual, 4.10s and 31's. I'm the slowest car out there, but I don't care. We're not racing...
Forum: TJ General Discussion Forum 11-09-2012, 06:23 AM
Replies: 5
Views: 627
Posted By Jeepn Again
That's a nice clean looking jeep. Great purchase....

That's a nice clean looking jeep. Great purchase. I'll trade ya!
Forum: TJ General Discussion Forum 11-06-2012, 07:59 PM
Replies: 2
Views: 506
Posted By Jeepn Again
I bought my 98 with the drivers side mirror epoxy...

I bought my 98 with the drivers side mirror epoxy welded together at the hinge joint. Didn't like that look so I just ordered an exact matching aftermarket mirror. The entire thing with new mounting...
Forum: TJ General Discussion Forum 11-06-2012, 06:53 AM
Replies: 17
Views: 1,162
Posted By Jeepn Again
I was kinda in the same boat. Looked for a 4.0...

I was kinda in the same boat. Looked for a 4.0 when buying, but my jeep came up and was only the 2.5. But the jeep was so clean and low mileage that I couldn't pass it up. I had owned a 2.5 YJ years...
Forum: TJ Tech Forum 11-04-2012, 08:23 AM
Replies: 21
Views: 2,803
Posted By Jeepn Again
Mine make the ticking exhaust manifold noise. I...

Mine make the ticking exhaust manifold noise. I figure that's what it is anyway. Goes away after warming up for a minute. Guessing its such a minor leak that its not worth fixing? Any reason to spend...
Forum: TJ General Discussion Forum 11-02-2012, 10:41 PM
Replies: 4
Views: 837
Posted By Jeepn Again
It depends on the model years. I traded my 98...

It depends on the model years. I traded my 98 half for 04 doors. Different size locks and holes in the doors. It was easy to jut get the new doors and locks keyed to your existing keys. Either do...
Forum: TJ General Discussion Forum 11-01-2012, 07:48 PM
Replies: 6
Views: 500
Posted By Jeepn Again
That's a really fair price. But fellow forum...

That's a really fair price. But fellow forum members convinced me to install my own 2" lift. Glad I did too. Doesn't take too long if you have the proper tools. I was done in under 4 hours, never...
Forum: TJ General Discussion Forum 11-01-2012, 07:28 AM
Replies: 9
Views: 734
Posted By Jeepn Again
I just installed new full doors. Had to adjust...

I just installed new full doors. Had to adjust them out to close right. Don't know anything about the bushings, but the doors both close like new and the gaps look factory. I loosened the top hinge...
Forum: TJ General Discussion Forum 11-01-2012, 06:56 AM
Replies: 10
Views: 848
Posted By Jeepn Again
I ordered mine through my local store. They were...

I ordered mine through my local store. They were cheaper than all online places, free shipping to them. They had it in 2 or 3 days after ordering. Yes, had to pay sales tax but it was worth talking...
Forum: General Jeep Discussion 10-31-2012, 06:57 AM
Replies: 4
Views: 541
Posted By Jeepn Again
Just completed that project. Traded another...

Just completed that project. Traded another member doors. I took the easy route and brought my cylinder to my local lock smith. $30 per cylinder and he had them done in a day. Yes, it would be...
Forum: TJ General Discussion Forum 10-25-2012, 07:38 AM
Replies: 14
Views: 658
Posted By Jeepn Again
I don't know about sidewall strength, but in my...

I don't know about sidewall strength, but in my experience BFG A/T have worked great for me. Quiet on the road and last for ever. Ok, not for ever but got 65k out of my last set on my pickup....
Showing results 1 to 25 of 68

 
Forum Jump

All times are GMT -5. The time now is 06:32 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC