Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 36
Search took 0.33 seconds.
Search: Keyword(s): ; Posts Made By: hrun
Forum: TJ Tech Forum 04-28-2014, 08:40 PM
Replies: 15
Views: 476
Posted By hrun
Don't use the "poly" riveter shown in the link...

Don't use the "poly" riveter shown in the link it's nor made for metal rivets.

Drill through the center of the rivet head where the stem pulled through, start with a small drill bit then step up...
Forum: North Carolina Jeep Forum 04-05-2014, 09:40 PM
Replies: 15
Views: 1,218
Posted By hrun
I don't do Facebook is there another way to get...

I don't do Facebook is there another way to get access to the latest information on the event. How do I register or signup to attend the event.
Forum: TJ General Discussion Forum 03-27-2014, 06:17 PM
Replies: 7
Views: 414
Posted By hrun
I also used superglue to repair on both sides of...

I also used superglue to repair on both sides of the split post. Then I coated the outside of the post with superglue and wrapped thread around the post to reinforce the glue joint. The repair has...
Forum: TJ Tech Forum 09-09-2013, 08:01 PM
Replies: 10
Views: 409
Posted By hrun
Found I had the same problem on my climate...

Found I had the same problem on my climate control knob. Pulled knob off found the plastic "sleeve" was cracked on each side of the sleeve. Inside the sleeve is a metal "D" shaped liner made of...
Forum: TJ Tech Forum 07-15-2013, 08:28 PM
Replies: 10
Views: 1,508
Posted By hrun
If your AC is set on the "Recirculate" position;...

If your AC is set on the "Recirculate" position; during high humidity the vents will blow out condensation and you may find water dripping on the passenger floor. Just change the AC setting to pull...
Forum: TJ General Discussion Forum 06-28-2013, 09:12 PM
Replies: 78
Views: 4,519
Posted By hrun
I've put a total of over 1,500,000 miles on 5...

I've put a total of over 1,500,000 miles on 5 different vehicles since 1987. All of them were serviced with conventional motor oil. Most of the oil changes were done at around 5,000 miles on...
Forum: TJ Tech Forum 05-28-2013, 09:15 PM
Replies: 10
Views: 440
Posted By hrun
If the tap was heat treated carbon steel; you can...

If the tap was heat treated carbon steel; you can use a center punch and hammer to chip the broken tap out. If its the better quality HSS (High speed steel) chipping it out with a hammer and punch...
Forum: TJ General Discussion Forum 05-28-2013, 08:38 PM
Replies: 7
Views: 507
Posted By hrun
Check out Bestop Sailcloth Replace-a-Top for...

Check out Bestop Sailcloth Replace-a-Top for Wrangler TJ 97-02 | 4WheelOnline.com (http://4wheelonline.com/jeep/Bestop_Sailcloth_Replace-a-Top_for_Wrangler_TJ_97_02.169622.11243)

They have the...
Forum: North Carolina Jeep Forum 05-20-2013, 08:44 PM
Replies: 1
Views: 207
Posted By hrun
Bay Tree Lake State Park. No facilities just...

Bay Tree Lake State Park. No facilities just trails that go back to the lake. Can be muddy in places especially if it has rained recently.
Forum: TJ General Discussion Forum 05-12-2013, 07:49 AM
Replies: 22
Views: 25,558
Posted By hrun
I've used Black RTV to repair the edge of the top...

I've used Black RTV to repair the edge of the top where the material has pulled away from the sewn seam. I squirt the RTV under the layer of material, then apply a layer of RTV over the torn seam. ...
Forum: TJ General Discussion Forum 05-09-2013, 06:50 PM
Replies: 14
Views: 7,304
Posted By hrun
Had the original brass radiator in my 89 Toyota...

Had the original brass radiator in my 89 Toyota truck develop a hole in the top. Used JB weld to patch the hole pressed the ball of epoxy into the hole and let set overnight never had a failure. I...
Forum: TJ General Discussion Forum 04-25-2013, 06:49 PM
Replies: 7
Views: 367
Posted By hrun
The factory sailcloth is worth fixing. I have...

The factory sailcloth is worth fixing. I have the original sailcloth top on my 2001 TJ. Other than the velcro wearing out on the windows the top is still in good shape. I'll be replacing it this...
Forum: TJ Tech Forum 04-15-2013, 05:03 PM
Replies: 1
Views: 845
Posted By hrun
CEL code P0442 & P0455

Just had CEL come on; checked with code scanner and have the following codes P0442 & P0455. The P0455 code also returned the following information "DTCFRZF". I checked the factory service manual...
Forum: TJ Tech Forum 03-02-2013, 06:20 PM
Replies: 14
Views: 1,036
Posted By hrun
Try using the following bolt extractor set: ...

Try using the following bolt extractor set:

Metric:

9 Piece 3/8" Drive Metric Bolt Extractor Sockets (http://www.harborfreight.com/9-piece-38-drive-metric-bolt-extractor-sockets-67894.html)
...
Forum: TJ General Discussion Forum 08-20-2012, 07:10 PM
Replies: 21
Views: 960
Posted By hrun
I currently have 30 x 9.5 x 15 tires on my TJ and...

I currently have 30 x 9.5 x 15 tires on my TJ and have gotten between 18-20 MPG Hwy; city Hwy combined 16-18. I get the best mileage using the cruise control at 65-67 MPH on the interstate. Have...
Forum: TJ General Discussion Forum 07-14-2012, 12:05 PM
Replies: 2
Views: 1,205
Posted By hrun
Jerry, Thanks for the picture, it helps.

Jerry,

Thanks for the picture, it helps.
Forum: TJ General Discussion Forum 07-14-2012, 10:31 AM
Replies: 2
Views: 1,205
Posted By hrun
Fill Plug Location NV3550

Need to change transmission lubricant in my 2001 TJ. What side of the NV3550 transmission is the fill plug on? Driver side or passenger side? Does the transfer case skid plate need to be removed...
Forum: TJ General Discussion Forum 07-06-2012, 04:35 PM
Replies: 11
Views: 703
Posted By hrun
I'll have to agree that the HFT clicker torque...

I'll have to agree that the HFT clicker torque wrenches are worth buying. Having access to a torque tester at work for calibration; I've tested all 3 sizes from HFT. They are well within the +/- 4%...
Forum: Classifieds Archive 07-05-2012, 10:43 AM
Replies: 1
Views: 441
Posted By hrun
Bumper parts no longer available

Bumper parts no longer available
Forum: TJ General Discussion Forum 06-29-2012, 07:32 PM
Replies: 9
Views: 3,083
Posted By hrun
U-Joints for 2001 TJ

I'll be replacing the U-Joints on my 2001 TJ soon. How are the NAPA Store Brand? Anyone know who makes them for NAPA. I thought they were made by Spicer just not sure.

I'm considering using the...
Forum: Classifieds Archive 06-12-2012, 08:35 PM
Replies: 1
Views: 441
Posted By hrun
2001 TJ Bumper Parts

Have stock 2001 TJ rear bump with both the jugs and Mopar flat end caps. The end caps are new in bag never mounted.

End caps $10.00
Bumper w/jugs $20.00

Also have front bumper jugs without...
Forum: Tires & Wheels 06-06-2012, 08:00 PM
Replies: 2
Views: 775
Posted By hrun
31" tires & 3.73 gears

What affect will 31" tires have on my 2001 TJ with 4.0 engine? I have 3.73 gears and a 5 speed manual. I currently am running 30 x 9.5 x 15 with no problem. Would like to try 31" Goodyear...
Forum: TJ General Discussion Forum 06-06-2012, 07:27 PM
Replies: 11
Views: 814
Posted By hrun
Correct position of softtop when down

What is the correct position of softtop when down? Does it rest bellow the tail gate and side rails of the tub; or rest above them?
Forum: TJ General Discussion Forum 05-21-2012, 06:36 PM
Replies: 8
Views: 1,113
Posted By hrun
have you checked out the ZJ Tie Rod conversion on...

have you checked out the ZJ Tie Rod conversion on Stu Olson's web site:

ZJ Tie Rod Conversion (http://www.stu-offroad.com/steering/zjtie/tierod-1.htm)

He lists the parts required and shows the...
Forum: TJ General Discussion Forum 02-22-2012, 08:58 PM
Replies: 19
Views: 916
Posted By hrun
You can repair most split, cracks or cuts in the...

You can repair most split, cracks or cuts in the soft window with a vinyl swimming pool liner repair kit. These kits are about $10.00 from your local pool supply. You want the kit that has...
Showing results 1 to 25 of 36

 
Forum Jump

All times are GMT -5. The time now is 09:49 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC