Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 208
Search took 0.30 seconds.
Search: Keyword(s): ; Posts Made By: 12thman
Forum: JK General Discussion Forum 07-03-2014, 11:32 PM
Replies: 32
Views: 620
Posted By 12thman
You are right. I used radius instead of diameter...

You are right. I used radius instead of diameter effectively halving the circumference. Percent of change and the point of the post remain the same.
Forum: JK Tech Forum 07-02-2014, 08:29 PM
Replies: 85
Views: 2,758
Posted By 12thman
I don't. In California, it's mandatory now in all...

I don't. In California, it's mandatory now in all grades. When I lived in South Dakota in the 90s, all stations carried ethanol 89 octane and it was cheaper than 87. Maybe it's only available in 89...
Forum: JK General Discussion Forum 07-01-2014, 08:00 AM
Replies: 32
Views: 620
Posted By 12thman
I set them at 25 pounds since I run 29.

I set them at 25 pounds since I run 29.
Forum: JK General Discussion Forum 07-01-2014, 04:08 AM
Replies: 32
Views: 620
Posted By 12thman
I have a 14 JKU on 315 Duratracs, too. The Procal...

I have a 14 JKU on 315 Duratracs, too. The Procal took all of about two minutes to change my tire size and TPMS settings. Very easy.
Forum: JK Tech Forum 07-01-2014, 01:51 AM
Replies: 85
Views: 2,758
Posted By 12thman
Pasting some info I'm tired of retyping: ...

Pasting some info I'm tired of retyping:

Octane is not a measurement of "power". It is a reference to how resistent the fuel is to auto-ignition under compression. The higher the number, the more...
Forum: JK General Discussion Forum 06-30-2014, 10:15 PM
Replies: 32
Views: 620
Posted By 12thman
This is simple math. A 31" tire has a...

This is simple math. A 31" tire has a circumference of 48.7". A 35" tire has a circumference of 55". Without reprogramming for correct size the speedometer will be off by 11.5%. That means your...
Forum: JK Tech Forum 06-30-2014, 08:51 AM
Replies: 14
Views: 471
Posted By 12thman
I second this. We also have an ACE lumber yard in...

I second this. We also have an ACE lumber yard in town. Better prices and when you pull around back, they load it up for you.
Forum: JK General Discussion Forum 06-27-2014, 10:36 PM
Replies: 727
Views: 65,745
Posted By 12thman
True. I got .75 spacers with my JKU lift.

True. I got .75 spacers with my JKU lift.
Forum: JK General Discussion Forum 06-27-2014, 03:10 AM
Replies: 33
Views: 1,002
Posted By 12thman
Take a look at my write - up on this carrier: ...

Take a look at my write - up on this carrier:
http://www.wranglerforum.com/f202/redrock-4x4-hinged-tire-carrier-install-write-up-766482.html
Forum: JK Tech Forum 06-25-2014, 02:50 PM
Replies: 22
Views: 605
Posted By 12thman
I'm not looking for a fight, either. You said it...

I'm not looking for a fight, either. You said it was a "night and day difference" between the two and I would be "better off in the long run" going with the Teraflex. I was surprised to see that...
Forum: JK General Discussion Forum 06-25-2014, 01:45 PM
Replies: 150
Views: 3,525
Posted By 12thman
Tesoro

Tesoro
Forum: JK Tech Forum 06-25-2014, 10:06 AM
Replies: 22
Views: 605
Posted By 12thman
You've installed and used both?

You've installed and used both?
Forum: JK General Discussion Forum 06-25-2014, 10:02 AM
Replies: 150
Views: 3,525
Posted By 12thman
Same thing. Operator and ERT.

Same thing. Operator and ERT.
Forum: JK General Discussion Forum 06-25-2014, 03:32 AM
Replies: 150
Views: 3,525
Posted By 12thman
I do the same thing in the Bay Area. Brentwood,...

I do the same thing in the Bay Area. Brentwood, CA here.
Forum: JK Tech Forum 06-24-2014, 11:47 PM
Replies: 22
Views: 605
Posted By 12thman
Thanks. After installing my Bushwacker flat...

Thanks. After installing my Bushwacker flat fenders, I know how helpful a good write - up can be.
Forum: JK Tech Forum 06-24-2014, 04:51 PM
Replies: 22
Views: 605
Posted By 12thman
That's it. Mount your spare to the carrier and...

That's it. Mount your spare to the carrier and off you go. Like
I said, I bought $13 worth of bolts and washers and a $7 can of bed liner for a total of around $420. It feels very solid when...
Forum: JK Tech Forum 06-24-2014, 04:43 PM
Replies: 22
Views: 605
Posted By 12thman
Step 10: "Using the factory hardware, mount the...

Step 10: "Using the factory hardware, mount the brake light to the new bracket and route the wires into the door using the factory grommet and wiring harness."
Forum: JK Tech Forum 06-24-2014, 04:41 PM
Replies: 22
Views: 605
Posted By 12thman
Step 8: "Align the door and tighten all bolts...

Step 8: "Align the door and tighten all bolts down to ensure they are tight to the vehicle." This is where you will tighten everything you've left loose. The carrier should be torqued down to the...
Forum: JK Tech Forum 06-24-2014, 04:34 PM
Replies: 22
Views: 605
Posted By 12thman
Step 7: "Bolt the rest of the tire carrier to the...

Step 7: "Bolt the rest of the tire carrier to the rear door using the (8) 10mm supplied bolts. The mount will reuse all factory mounting points." You will have to go back and forth tightening each...
Forum: JK Tech Forum 06-24-2014, 04:30 PM
Replies: 22
Views: 605
Posted By 12thman
Step 6: "Using the long 10mm bolts supplied with...

Step 6: "Using the long 10mm bolts supplied with this mount, slide them through the carrier and through the supplied spacers to bolt it to the rear door. Note, the longer spacers will be used closer...
Forum: JK Tech Forum 06-24-2014, 04:26 PM
Replies: 22
Views: 605
Posted By 12thman
Step 5: "Mount the new tire carrier to the hinges...

Step 5: "Mount the new tire carrier to the hinges using the supplied 21mm mounting bolts and 22mm nuts to hold it in position." In the initial installation, i followed this instruction. The problem...
Forum: JK Tech Forum 06-24-2014, 04:17 PM
Replies: 22
Views: 605
Posted By 12thman
Step 4: "Install the replacement hinge hardware...

Step 4: "Install the replacement hinge hardware to the factory mounting points using the factory hardware." Don't torque these down all the way. You will need to adjust them later.
Forum: JK Tech Forum 06-24-2014, 04:14 PM
Replies: 22
Views: 605
Posted By 12thman
Step 2 is: "Remove the (8) 10mm bolts holding the...

Step 2 is: "Remove the (8) 10mm bolts holding the tire carrier to the rear of the vehicle." You will also need to disconnect the wiring harness for the 3rd brake light before doing this. After...
Forum: JK Tech Forum 06-24-2014, 04:06 PM
Replies: 22
Views: 605
Posted By 12thman
In the box is two pages of instructions with...

In the box is two pages of instructions with color pictures. Step 1 in the instructions is: "Remove the rear wheel, then pull the hinge covers off by unsnapping them from the hinge assembly." That...
Forum: JK Tech Forum 06-24-2014, 04:01 PM
Replies: 22
Views: 605
Posted By 12thman
The coating on the parts is pretty thin and...

The coating on the parts is pretty thin and chipping off at the edges. I bought a can of Rustoleum Truck Bed Liner and sprayed all the coated parts before install. The can was about $7 at Lowes.
Showing results 1 to 25 of 208

 
Forum Jump

All times are GMT -5. The time now is 01:27 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC