Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 0.19 seconds.
Search: Keyword(s): ; Posts Made By: twister4399
Forum: YJ Pics Forum Yesterday, 11:24 PM
Replies: 1
Views: 123
Posted By twister4399
This appears to be the only one I have. The net...

This appears to be the only one I have. The net is still on but the hard top is covering it.

1955146
Forum: YJ Tech Forum 02-28-2015, 05:19 PM
Replies: 6
Views: 217
Posted By twister4399
I thought the headlight buzzer was tied to the...

I thought the headlight buzzer was tied to the door light switches? Check on the driver door behind the plunger there should be two spade terminals. I thin one is for lights one is for buzzer.
Forum: YJ Tech Forum 02-28-2015, 04:47 PM
Replies: 7
Views: 346
Posted By twister4399
You checked to make sure you have power to the...

You checked to make sure you have power to the fuel pump and the coil? It the check engine light is not coming on when the key is moved to the on position then odds are the ecu is dead. That is how a...
Forum: YJ Tech Forum 02-25-2015, 07:44 AM
Replies: 14
Views: 1,359
Posted By twister4399
Your right on the O2 and light. So I'll throw...

Your right on the O2 and light. So I'll throw this out there is the Check engine light burnt out? It should come on with the first turn of the key. The only other thing I can throw out there is what...
Forum: YJ General Discussion Forum 02-25-2015, 07:34 AM
Replies: 19
Views: 710
Posted By twister4399
I think it depends on the year. The 94 will fold...

I think it depends on the year. The 94 will fold up to the front seats then If I remember correctly there were some cotter pins to pull and it came right out.
Forum: YJ Tech Forum 02-24-2015, 07:51 AM
Replies: 14
Views: 1,359
Posted By twister4399
If it's a bad TPS it will more than likely do it...

If it's a bad TPS it will more than likely do it at the same throttle position. There is another thread on how to check the TPS with an ohm meter. Sounds like you have an O2 problem or a vac leak. I...
Forum: YJ Tech Forum 02-22-2015, 12:02 PM
Replies: 14
Views: 1,359
Posted By twister4399
Has the tank been modified. I have heard that...

Has the tank been modified. I have heard that some people have removed the baffles around the pump and when it's not full the fuel splashes around causing issues. Also cheap insurance if it hasn't...
Forum: YJ Tech Forum 02-22-2015, 11:59 AM
Replies: 19
Views: 499
Posted By twister4399
Hope it all works out. Would like to see pics...

Hope it all works out. Would like to see pics when you get time.
Forum: YJ Tech Forum 02-21-2015, 09:52 PM
Replies: 11
Views: 558
Posted By twister4399
1926090

1926090
Forum: YJ Tech Forum 02-21-2015, 09:51 PM
Replies: 11
Views: 558
Posted By twister4399
Here is a pic of mine. Should hook right to...

Here is a pic of mine. Should hook right to intake manifold under the air filter tube. App won't let me post more than one pic at a time.



1926082
Forum: YJ Tech Forum 02-21-2015, 09:41 PM
Replies: 19
Views: 499
Posted By twister4399
That's excellent advice. Pop all bolts to just...

That's excellent advice. Pop all bolts to just finger tight during assembly then you should be able to shove it around.
Forum: YJ Tech Forum 02-21-2015, 09:37 PM
Replies: 7
Views: 346
Posted By twister4399
Check all fuses related to starting. Ignition and...

Check all fuses related to starting. Ignition and everything.
Forum: YJ Tech Forum 02-15-2015, 08:38 PM
Replies: 1
Views: 141
Posted By twister4399
Make sure all the grounds are clean and tight. I...

Make sure all the grounds are clean and tight. I would probably pull all the grounds and clean with wire brush just to make sure.
Forum: YJ General Discussion Forum 02-14-2015, 02:38 PM
Replies: 19
Views: 710
Posted By twister4399
Removed my back seat 3 years ago as well as all...

Removed my back seat 3 years ago as well as all the brackets and threw in a rubber mat for the dogs.
Forum: YJ Tech Forum 02-14-2015, 02:28 PM
Replies: 4
Views: 375
Posted By twister4399
I think I would start by unplugging that and...

I think I would start by unplugging that and plugging the O2 back in and see how it runs. Those boxes are usually just a resister that tricks the ecu into dumping too much or too little fuel. It also...
Forum: YJ Tech Forum 02-14-2015, 02:12 PM
Replies: 4
Views: 187
Posted By twister4399
Sorry I don't have a direct answer but the...

Sorry I don't have a direct answer but the easiest way to tell is crawl under and measure the cap size. I know the 95s had the larger joints on the front axle but not sure if they changed them on the...
Forum: YJ Pics Forum 02-05-2015, 07:54 PM
Replies: 2
Views: 340
Posted By twister4399
Nice I had a 53 M38A1 when I was in high school....

Nice I had a 53 M38A1 when I was in high school. I still miss it but the YJ is far more practical.
Forum: YJ Tech Forum 01-25-2015, 06:41 PM
Replies: 28
Views: 364
Posted By twister4399
Have you checked and cleaned all the grounds? You...

Have you checked and cleaned all the grounds? You might have bumped a ground cable that is causing that issue.
Forum: YJ General Discussion Forum 01-25-2015, 06:06 PM
Replies: 11,858
Views: 563,499
Posted By twister4399
Changed the trans fluid and fuel filter. Trans...

Changed the trans fluid and fuel filter. Trans seems much smoother with the Napa synthetic 10-30 vs Dino 10-30.
Forum: YJ Tech Forum 01-21-2015, 07:34 AM
Replies: 9
Views: 523
Posted By twister4399
My 94s dome good and floor lights didn't work....

My 94s dome good and floor lights didn't work. There was a fuse missing in the box under the hood. That's the fuse I pull when going without doors too. I think it's a little 5 or 10 amp but it is for...
Forum: YJ Tech Forum 01-18-2015, 12:55 AM
Replies: 7
Views: 307
Posted By twister4399
Besides bad bulb be sure that all bulb contacts...

Besides bad bulb be sure that all bulb contacts and sockets are clean. I had a rear bulb that was not blown but the nub that makes contact in the socket had a little grime and the nub was flat...
Forum: YJ General Discussion Forum 12-31-2014, 09:00 AM
Replies: 4
Views: 225
Posted By twister4399
Check front and rear sockets for corrosion. Clean...

Check front and rear sockets for corrosion. Clean really well and put dielectric grease in the connections. I had a problem with both rear lights recently that the little buttons for connections on...
Forum: YJ Pics Forum 12-17-2014, 07:47 PM
Replies: 22
Views: 2,824
Posted By twister4399
You guys with 31s and stock wheels have any...

You guys with 31s and stock wheels have any issues and are you running 10.5 width? Looking to go up 2" soon and will replace the 30x9.5s when they are done.
Forum: YJ Tech Forum 12-17-2014, 07:38 AM
Replies: 33
Views: 1,650
Posted By twister4399
These guys will need more pics of the steering...

These guys will need more pics of the steering linkage to tell if it's been updated or left stock. Just a guess but with tires that large and if it was left on stock setup the tie rod ends might be...
Forum: YJ General Discussion Forum 12-13-2014, 12:09 PM
Replies: 9
Views: 461
Posted By twister4399
I just drilled mine then used heat and it came...

I just drilled mine then used heat and it came right out.
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 07:21 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC