Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 250
Search took 0.32 seconds.
Search: Keyword(s): ; Posts Made By: chevymad
Forum: TJ Tech Forum 08-19-2014, 11:38 PM
Replies: 15
Views: 407
Posted By chevymad
I have the opposite problem with mine. Sometime...

I have the opposite problem with mine. Sometime someone has dropped something into my heater. If I go up a steep hill it will get stuck on vents only, can't get defrost or heater. Then I take the...
Forum: TJ Tech Forum 08-07-2014, 10:07 PM
Replies: 12
Views: 517
Posted By chevymad
Just a tip. Easiest way I've found for removing...

Just a tip. Easiest way I've found for removing those clips is to take a rag and drag it behind the handle between the handle and door panel. The rag will snag the end of the clip and remove it from...
Forum: TJ Tech Forum 08-02-2014, 12:56 PM
Replies: 12
Views: 302
Posted By chevymad
Mine did the same and even would push fluid out...

Mine did the same and even would push fluid out on hard freeway climbs. Radiator cap stopped all that.
Forum: TJ Tech Forum 08-02-2014, 12:34 PM
Replies: 4
Views: 219
Posted By chevymad
I'm using the Zone lift and it works well. I...

I'm using the Zone lift and it works well. I added a set of metalcloak control arms and a jks trackbar to it as well. The control arms aren't really needed for most but an adjustable track bar is a...
Forum: TJ Tech Forum 07-23-2014, 11:59 PM
Replies: 77
Views: 3,954
Posted By chevymad
I didn't see where anyone said anything about...

I didn't see where anyone said anything about tj's coming with widebands. And as for no tj's having one mine currently does. It may be a TJ tech board but we're talking about a jeep with a...
Forum: TJ Tech Forum 07-23-2014, 08:13 PM
Replies: 77
Views: 3,954
Posted By chevymad
Exactly what I was going to say. Also some...

Exactly what I was going to say. Also some manufacturers will monitor how much variation between the front and rear sensors. So if the fronts are saying lean, but the rears say rich for too long of a...
Forum: TJ Tech Forum 07-23-2014, 09:34 AM
Replies: 77
Views: 3,954
Posted By chevymad
It's fairly easy. You need to wire into each o2...

It's fairly easy. You need to wire into each o2 sensor. My jeep seems to be fine wired into just the front sensors. No codes setting or anything without doing the rears. After that you use a volt...
Forum: TJ General Discussion Forum 07-22-2014, 10:14 PM
Replies: 7
Views: 381
Posted By chevymad
Made my own harness. They're BP1210-h4's $10.29...

Made my own harness. They're BP1210-h4's $10.29 each at our local store.

Looking back to see when I got these.. been at least a 1.5 years.. maybe almost 2.
Forum: TJ General Discussion Forum 07-21-2014, 11:25 PM
Replies: 7
Views: 381
Posted By chevymad
I'm running 80/100s from Napa. Been in over a...

I'm running 80/100s from Napa. Been in over a year no problems yet.
Forum: TJ Tech Forum 07-21-2014, 11:20 PM
Replies: 38
Views: 791
Posted By chevymad
Lol.. a description I made up just to try and...

Lol.. a description I made up just to try and get my point across. This was and open sided bearing with 5 or 6 balls in it. Definately not a tapered roller.
Forum: TJ Tech Forum 07-21-2014, 11:18 PM
Replies: 77
Views: 3,954
Posted By chevymad
Got the Enricher installed. Had a slight issue...

Got the Enricher installed. Had a slight issue afterwards. I've been using my Innovate wideband's narrowband simulated output for the rear O2 sensor signal to the PCM. Innovate pre-progams that...
Forum: TJ Tech Forum 07-21-2014, 11:06 PM
Replies: 38
Views: 791
Posted By chevymad
Apparently you didn't read my post. I said that 3...

Apparently you didn't read my post. I said that 3 of mine. .both new ones and 1 of the ones that was in the jeep are the way Jerry's pic shows. But one of them was not it was a ball bearing roller...
Forum: TJ Tech Forum 07-20-2014, 11:42 PM
Replies: 38
Views: 791
Posted By chevymad
Jerry there apparently is some kind of...

Jerry there apparently is some kind of replacement bearing out there that is not a tapered bearing. I recently replaced my axles and both new ones are as you have shown, but only one that was in the...
Forum: TJ Tech Forum 07-20-2014, 04:26 PM
Replies: 38
Views: 791
Posted By chevymad
Weld something to the end to use as a handle.

Weld something to the end to use as a handle.
Forum: Oregon Jeep Forum 07-16-2014, 12:32 AM
Replies: 5
Views: 249
Posted By chevymad
Had to replace my radiator a couple weeks ago.....

Had to replace my radiator a couple weeks ago.. noticed it coming a little above the 210 mark. Got home and felt across the tubes and about a 1/3 of it was cold - no flow.
Forum: General Jeep Discussion 07-12-2014, 09:52 PM
Replies: 44
Views: 2,230
Posted By chevymad
This is the kind of thing we all worry about....

This is the kind of thing we all worry about. Both the new cherokee and the renegade are said to be "unliftable" do to their suspension systems.

Lifted Jeep Cherokee Dakar - Automotive Design -...
Forum: General Jeep Discussion 07-12-2014, 04:46 PM
Replies: 44
Views: 2,230
Posted By chevymad
I wouldn't say raging about something at this...

I wouldn't say raging about something at this time is pointless. I'm sure threads like these are seen by somebody who works for jeep. It tells jeep what the enthusiasts are actually looking for and...
Forum: TJ Tech Forum 07-10-2014, 11:31 PM
Replies: 77
Views: 3,954
Posted By chevymad
I have and Innovate allready. I don't have to...

I have and Innovate allready. I don't have to smog here at all so that isn't an issue. If I did washington does it every year too.. Good thing I live in the sticks.
Forum: TJ Tech Forum 07-09-2014, 11:14 PM
Replies: 77
Views: 3,954
Posted By chevymad
I think the real issue with my 2003 is that its a...

I think the real issue with my 2003 is that its a california emission, ULEV vehicle.. with the 3 cats. Probably alot of extra control there to get the ULEV rating.
Forum: TJ Tech Forum 07-09-2014, 11:12 PM
Replies: 77
Views: 3,954
Posted By chevymad
I'm going to try a hybrid setup. This split...

I'm going to try a hybrid setup. This split second enricher to solve the closed loop problem and the 7th injector controlled by the split second tuner i currently have to add the extra fuel. From...
Forum: TJ Tech Forum 07-08-2014, 11:07 PM
Replies: 77
Views: 3,954
Posted By chevymad
Does the TB mount on the back of the m90 like the...

Does the TB mount on the back of the m90 like the m62? With a cobra head adapter on my tb it is very close to rubbing the firewall. If the design is the same it wouldn't fit the way this kit is built.
Forum: TJ Tech Forum 07-08-2014, 11:04 PM
Replies: 77
Views: 3,954
Posted By chevymad
Reading on split seconds web site about their...

Reading on split seconds web site about their enricher. It looks to be made to cure exactly the problem I'm having.
Forum: TJ Tech Forum 07-07-2014, 10:29 PM
Replies: 77
Views: 3,954
Posted By chevymad
Just went and double checked plumbing.. stock map...

Just went and double checked plumbing.. stock map is T'd into the same line that the new map and boost gauge are plumbed on. So yes it does see boost.
Forum: TJ Tech Forum 07-07-2014, 10:25 PM
Replies: 77
Views: 3,954
Posted By chevymad
Stock map is on the throttle body. The tuner...

Stock map is on the throttle body. The tuner takes over the map signal at 0 vacuum. WoT and Accerlation >50%/3500 works fine. It's the last part that doesn't always work. Sometimes it can be sitting...
Forum: Oregon Jeep Forum 07-06-2014, 07:58 PM
Replies: 72
Views: 1,646
Posted By chevymad
That doesn't sound quite right... lol Did a...

That doesn't sound quite right... lol Did a tape measure alignment and it wasn't very far off.. so either drag link or track bar. The JKS track bar has a few marks in it.
Showing results 1 to 25 of 250

 
Forum Jump

All times are GMT -5. The time now is 09:52 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC