Jeep Wrangler Forum - Search Results
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > Search Forums

Join Wrangler Forum Today


Showing results 1 to 25 of 118
Search took 2.60 seconds.
Search: Keyword(s): ; Posts Made By: uniballer
Forum: TJ Tech Forum 08-03-2014, 11:16 PM
Replies: 14
Views: 487
Posted By uniballer
I will get the wheels rebalanced this weekend. ...

I will get the wheels rebalanced this weekend. The jeep is stock as a rock. I have to replace rotors and pads all around anyway, I'll go ahead an get the balance work after that and report back ...
Forum: TJ Tech Forum 08-03-2014, 02:30 PM
Replies: 14
Views: 487
Posted By uniballer
Okay, so I finally had an opportunity to do this....

Okay, so I finally had an opportunity to do this. Nothing looked or felt immediately off, but I'm admittedly no pro at this. Right now though, I'm suspecting ball joints, or a wallowing of a track...
Forum: TJ Tech Forum 05-23-2014, 10:24 PM
Replies: 14
Views: 487
Posted By uniballer
I assume "dry" means unassisted by power...

I assume "dry" means unassisted by power steering?

This might be tough for my 11yr old helper!
Forum: TJ Tech Forum 05-23-2014, 02:08 PM
Replies: 14
Views: 487
Posted By uniballer
Thanks man! I am in the same boat. Trying to...

Thanks man! I am in the same boat. Trying to work towards a full lift/wheel/tire swap and having to replace the bits I'll have to be replacing again really grinds my gears!
Forum: TJ Tech Forum 05-23-2014, 02:06 PM
Replies: 14
Views: 487
Posted By uniballer
Thanks, that sounds like a good place to start.

Thanks, that sounds like a good place to start.
Forum: TJ Tech Forum 05-23-2014, 01:25 PM
Replies: 14
Views: 487
Posted By uniballer
2004 Rubicon Death Wobble?

So it seems I've caught a case of the death wobbles. Track bar was a little loose, and I replaced it, and that seemed to straighten it out for a little bit. However, now when I'm between 55 and...
Forum: TJ Tech Forum 03-15-2014, 09:58 PM
Replies: 4
Views: 470
Posted By uniballer
So I took the track bar back to O'Reillys and...

So I took the track bar back to O'Reillys and they warranted it without issue. Always have a great customer service experience there, for what it's worth. Anyway, I had to drive to another location...
Forum: TJ Tech Forum 03-15-2014, 12:53 PM
Replies: 4
Views: 470
Posted By uniballer
Well, I didn't see any rips on it when I took it...

Well, I didn't see any rips on it when I took it out of the box, which means I may have done it while wrenching it. Seems unlikely that there wasn't some sort of defect, but I can't prove it. ...
Forum: TJ Tech Forum 03-15-2014, 02:37 AM
Replies: 4
Views: 470
Posted By uniballer
So... this happened

Caught a case of the death wobble, and the track bar was the only thing with obvious play in it, so I ordered a Moog part (the jeep is still stock height, feel free to judge me). I put it all back...
Forum: TJ Tech Forum 02-17-2014, 12:22 AM
Replies: 1
Views: 248
Posted By uniballer
Oil Pressure Issue

Something odd just started happening with my 2004 TJ, the oil pressure gauge will drop to zero, it flashes the "check gauges" light and beeps, then it goes right back to normal operating pressure...
Forum: Classifieds Archive 04-12-2013, 11:02 PM
Replies: 42
Views: 9,034
Posted By uniballer
Beautiful jeep. I'm bumping for you, and playing...

Beautiful jeep. I'm bumping for you, and playing the lottery for me. If I win, you are on the short list for an immediate call.
Forum: TJ General Discussion Forum 10-27-2012, 12:13 PM
Replies: 8
Views: 586
Posted By uniballer
I'm not sure getting a wife for a free winch is...

I'm not sure getting a wife for a free winch is all that cost effective in the long run... I'm going to hold out a bit.
Forum: TJ General Discussion Forum 10-20-2012, 10:09 PM
Replies: 26,683
Views: 1,271,583
Posted By uniballer
I'm looking for deep well steelies just like...

I'm looking for deep well steelies just like that. Where'd you get em? 15x8's I hope?
Forum: TJ General Discussion Forum 10-09-2012, 08:55 AM
Replies: 26,683
Views: 1,271,583
Posted By uniballer
Replaced the Blower Motor Resistor. Now I have...

Replaced the Blower Motor Resistor. Now I have options other than 100 hair dryers in the face! Next project will likely be replacing the blown sub in the console.
Forum: TJ General Discussion Forum 09-23-2012, 10:35 PM
Replies: 7
Views: 571
Posted By uniballer
I think it was pretty sharp either way, but it...

I think it was pretty sharp either way, but it looks like a nice job. Well done sir.
Forum: TJ General Discussion Forum 09-19-2012, 10:51 PM
Replies: 20
Views: 4,734
Posted By uniballer
Yes, sorry for the late reply!

Yes, sorry for the late reply!
Forum: TJ General Discussion Forum 09-15-2012, 03:57 AM
Replies: 20
Views: 4,734
Posted By uniballer
using the spray, a couple light coats, then a few...

using the spray, a couple light coats, then a few wet ones. That should keep you from getting a rough surface. I did all light coats on my wheels and it didn't work out well, then i heard that tip....
Forum: TJ General Discussion Forum 09-12-2012, 09:49 AM
Replies: 5
Views: 532
Posted By uniballer
Order the chips! It's important to look at the...

Order the chips! It's important to look at the colors in the sunlight. Makes a difference from just browsing the web. Some colors I thought I'd love didn't turn out as compatible as I would have...
Forum: TJ General Discussion Forum 08-23-2012, 12:00 AM
Replies: 18
Views: 2,161
Posted By uniballer
First of all, this is awesome. Thanks for...

First of all, this is awesome. Thanks for posting. I'm planning savvy under armor in my build and this was very useful to me. I think the biggest benefit of this modular approach is probably going...
Forum: TJ General Discussion Forum 08-17-2012, 10:16 PM
Replies: 4
Views: 574
Posted By uniballer
Did you put a cover sheet on your TPS report? ...

Did you put a cover sheet on your TPS report?
http://upload.wikimedia.org/wikipedia/en/7/75/Tps_report.png
Forum: TJ General Discussion Forum 08-14-2012, 09:01 PM
Replies: 26,683
Views: 1,271,583
Posted By uniballer
Well it looks great. I'll be interested to see...

Well it looks great. I'll be interested to see that dash solution too. I'm not real sure about those flat dashboard sections in the popular cages. I'm sure they are fine, but the old CJ driver in...
Forum: TJ General Discussion Forum 08-14-2012, 01:17 AM
Replies: 26,683
Views: 1,271,583
Posted By uniballer
Did you have to cut your dash to get that cage...

Did you have to cut your dash to get that cage in? Looked like it was full tubes to the floorpan.
Forum: JK General Discussion Forum 08-10-2012, 07:45 AM
Replies: 144
Views: 26,219
Posted By uniballer
I was planning on a stinger upgrade. I did the...

I was planning on a stinger upgrade. I did the numbers and it ended up being more numbers, so it makes sense. But after looking at the numbers I thought I would try to double them. So I'm going to...
Forum: Vendor Spotlight! Great Deals for Members. 07-31-2012, 11:24 AM
Replies: 613
Views: 38,664
Posted By uniballer
Just wanted to add my 2 cents. I bought my SW1...

Just wanted to add my 2 cents. I bought my SW1 TJ Trailmesh from Krawl Off-road about a month ago and I couldn't be happier. The delivery was prompt, and the product is excellent, and performs...
Forum: Pictures Forum 07-30-2012, 01:35 PM
Replies: 151
Views: 26,430
Posted By uniballer
Picked it up in May. Still mathing out the...

Picked it up in May. Still mathing out the excruciatingly expensive build plans. :)
http://jasonpbrown.net/files/2012/06/Photo-May-15-7-15-30-PM.jpg...
Showing results 1 to 25 of 118

 
Forum Jump

All times are GMT -5. The time now is 10:15 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC